Home » Stihl Manuals » Lawn & Garden » Stihl RE 90 » Manual Viewer

Stihl RE 90 Instruction Manual - Page 26

Switching the Pressure Washer On, and Off

Get Stihl RE 90 PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

English 10.2 Resetting the Ground Fault Circuit Interruptor To reset the ground fault circuit interruptor: 2 3 1 11 Switching the Pressure Washer On and Off ► Always hold and operate the pressure washer with one hand firmly on the spray gun and your other hand firmly on the spray lance. Always hold the pressure washer with two hands in this manner. To switch the pressure washer on: 0000-GXX-6482-A0 0000-GXX-5305-A0 ► If depressing the TEST button has interrupted the current and turned the LED (2) OFF, depress the RESET button (3). The LED should turn back ON again. ► If the LED does not turn ON after depressing the RESET button, the GFCI is not working. Disconnect the pressure washer from the power supply and have it inspected by an authorized STIHL servicing dealer before further use. 11 Switching the Pressure Washer On and Off 11.1 Switching On WARNING Never operate your pressure washer if it is damaged, improperly adjusted or maintained, not completely and securely assembled or not functioning properly, @ 5.5. To reduce the risk of personal injury, always wear proper clothing and protective apparel, including proper eye protection, when operating your pressure washer, @ 5.4. Before switching on: ► Make sure you have a secure and firm footing. ► Stand upright. ► Set the switch to the I position. NOTICE When the pressure washer is switched on, voltage fluctuations may occur under unfavorable mains conditions with a power line impedance greater than 0.15 Ohm. The voltage fluctuations may negatively affect other connected electrical appliances. 11.2 Switching Off To switch the pressure washer off: 0000-GXX-5306-A0 24 0458-814-8621-A

Section	Page
1 Introduction	4
2 Guide to Using this Manual	4
2.1 Signal Words	4
2.2 Symbols in Text	5
3 Main Parts	6
3.1 Pressure Washer	6
3.2 Spray Attachment	7
4 Safety Symbols on the Product	7
4.1 Pressure Washer	7
5 IMPORTANT SAFETY INSTRUCTIONS	8
5.1 General Safety Warnings and Instructions	8
5.2 Intended Use	10
5.3 Operator	10
5.4 Personal Protective Equipment	11
5.5 Pressure Washer	11
5.6 Power Supply Cord	12
5.7 Connecting the Water Supply	13
5.8 Using the Pressure Washer	14
5.8.1 Before Operation	14
5.8.2 Holding and Controlling the Pressure Washer	15
5.8.3 Working Conditions	16
5.8.4 Operating Instructions	17
6 Maintenance, Repair and Storage	18
6.1 Warnings and Instructions	18
7 Before Starting Work	19
7.1 Preparing the Pressure Washer for Operation	19
8 Assembling the Pressure Washer	20
8.1 Assembling Parts and Accessories	20
8.2 Connecting and Removing the High-Pressure Hose	21
8.2.1 Connecting the High-Pressure Hose	21
8.2.2 Removing the High-Pressure Hose	21
8.3 Spray Gun and Lance	22
8.3.1 Connecting the Spray Gun and Lance	22
8.3.2 Removing the Spray Gun and Lance	22
8.4 Inserting and Removing the Spray Nozzle	23
8.4.1 Inserting the Spray Nozzle	23
8.4.2 Removing the Spray Nozzle	24
9 Connecting the Water Supply	24
9.1 Connecting the Pressure Washer to the Mains Water Supply	24
10 Ground Fault Circuit Interruptor (GFCI)	25
10.1 Testing the Ground Fault Circuit Interruptor	25
10.2 Resetting the Ground Fault Circuit Interruptor	26
11 Switching the Pressure Washer On and Off	26
11.1 Switching On	26
11.2 Switching Off	26
12 During Operation	27
12.1 Activating and Locking the Spray Gun Trigger	27
12.2 Adding Detergents	27
12.3 Cleaning	28
13 After Finishing Work	29
13.1 Preparing for Transportation or Storage	29
13.2 Protecting the Pressure Washer in Winter Conditions	30
14 Transporting	31
14.1 Transporting the Pressure Washer	31
15 Storing	31
15.1 Storing the Pressure Washer	31
16 Cleaning	32
16.1 Cleaning the Pressure Washer	32
16.2 Cleaning the Nozzle and Spray Lance	32
16.3 Cleaning the Water Intake Screen	33
17 Inspection and Maintenance	34
17.1 Inspection and Maintenance Chart	34
17.2 Inspecting and Maintaining the Pressure Washer	35
17.3 Lubricating the Gaskets	35
18 Troubleshooting Guide	36
18.1 Pressure Washer	36
19 Specifications	38
19.1 STIHL RE 90	38
19.2 Symbols on the Pressure Washer	38
19.3 Engineering Improvements	38
20 Replacement Parts and Equipment	40
20.1 Genuine STIHL Replacement Parts	40
21 Disposal	40
21.1 Disposal of the Power Tool	40
22 Limited Warranty	40
22.1 STIHL Incorporated Limited Warranty Policy	40
23 Trademarks	40
23.1 Registered Trademarks	40
23.2 Common Law Trademarks	40
24 Addresses	41
24.1 STIHL Incorporated	41
1 Introducción	43
2 Acerca de este manual de instrucciones	43
2.1 Palabras identificadoras	43
2.2 Símbolos en el texto	44
3 Componentes importantes	45
3.1 Hidrolavadora	45
3.2 Accesorio pulverizador	46
4 Símbolos de seguridad en el producto	46
4.1 Hidrolavadora	46
5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD	47
5.1 Advertencias e instrucciones generales sobre seguridad	47
5.2 Uso previsto	49
5.3 Operador	50
5.4 Equipos de protección personal	50
5.5 Hidrolavadora	51
5.6 Cordón eléctrico	52
5.7 Conexión del suministro de agua	52
5.8 Uso de la hidrolavadora	53
5.8.1 Antes del uso	53
5.8.2 Sujeción y control de la hidrolavadora	54
5.8.3 Condiciones de trabajo	55
5.8.4 Instrucciones de manejo	56
6 Mantenimiento, reparación y almacenamiento	57
6.1 Advertencias e instrucciones	57
7 Antes de empezar a trabajar	59
7.1 Preparación de la hidrolavadora para el funcionamiento	59
8 Armado de la hidrolavadora	59
8.1 Armado de las piezas y accesorios	59
8.2 Conexión y desconexión de la manguera de alta presión	60
8.2.1 Conexión de la manguera de presión alta	60
8.2.2 Retiro de la manguera de alta presión	61
8.3 Pistola rociadora y lanza	61
8.3.1 Conexión de la pistola rociadora y de la lanza	61
8.3.2 Retiro de la pistola rociadora y de la lanza	62
8.4 Inserción y retiro de la boquilla	62
8.4.1 Inserción de la boquilla	62
8.4.2 Retiro de la boquilla	63
9 Conexión del suministro de agua	63
9.1 Conexión de la hidrolavadora al suministro de agua	63
10 Interruptor de pérdidas a tierra (GFCI)	65
10.1 Prueba del interruptor de pérdidas a tierra	65
10.2 Reposición del interruptor de pérdidas a tierra	65
11 Encendido y apagado de la hidrolavadora	66
11.1 Encendido	66
11.2 Apagado	66
12 Durante el funcionamiento	66
12.1 Activación y bloqueo del gatillo de la pistola rociadora	66
12.2 Adición de detergentes	67
12.3 Limpieza	68
13 Después de completar el trabajo	69
13.1 Preparación para el transporte o el almacenamiento	69
13.2 Protección de la hidrolavadora en condiciones de invierno	70
14 Transporte	71
14.1 Transporte de la hidrolavadora	71
15 Almacenamiento	71
15.1 Almacenamiento de la hidrolavadora	71
16 Limpieza	72
16.1 Limpieza de la hidrolavadora	72
16.2 Limpieza de la boquilla y de la lanza rociadora	72
16.3 Limpieza de la malla de admisión de agua	73
17 Inspección y mantenimiento	74
17.1 Tabla de inspección y mantenimiento	74
17.2 Inspección y mantenimiento de la hidrolavadora	75
17.3 Lubricación de las empaquetaduras	75
18 Guía de solución de problemas	76
18.1 Hidrolavadora	76
19 Especificaciones	78
19.1 STIHL RE 90	78
19.2 Símbolos en la hidrolavadora	78
19.3 Mejoramientos técnicos	78
20 Piezas y equipos de repuesto	80
20.1 Piezas de repuesto originales de STIHL	80
21 Eliminación	80
21.1 Desecho de la herramienta motorizada	80
22 Garantía limitada	80
22.1 Política de garantía limitada de STIHL Incorporated	80
23 Marcas comerciales	80
23.1 Marcas comerciales registradas	80
23.2 Marcas comerciales por ley común	80
24 Direcciones	81