Stihl HL Attachments Instruction Manual - Page 15

Adjusting the Cutter Bar Angle Adjuster - 145° 145° WARNING To reduce the risk of injury, never touch the blades while making adjustments. 2 3 1 N Pull back the sliding sleeve (1) and use the lever (2) to adjust the joint by one or several holes. N Release the sliding sleeve (1) and make sure the lock pin engages the quadrant (3). Transport Position 0000-GXX-1684-A0 English moving the cutter bar to the transport position or from the transport position to the normal working position. WARNING The gearbox gets hot during operation. To reduce the risk of burn injury, do not touch the gearbox. 0000-GXX-1683-A0 0000-GXX-1685-A0 The angle of th cutter bar can be adjusted upwards in 4 stages from 0° (straight) to 55°, and downwards in 7 stages from 0° to 90° (right angle facing down). There are therefore 12 possible working positions. WARNING To reduce the risk of injury, carry out the adjustment only when the cutting blades are at a standstill - engine at idle speed. WARNING The gearbox gets hot during operation. To reduce the risk of burn injury, do not touch the gearbox. The cutter bar can be folded flat against the drive tube and locked in position to save space during transportation. WARNING To reduce the risk of injury, always shut off the engine - depress stop switch - and fit the blade scabbard before HL-KM 13