Stihl HL 56 K Instruction Manual - Page 21

N Pull the starter grip slowly with your right hand until you feel it engage and then continue pulling it slowly and steadily. Do not pull out the starter rope to full length - it might otherwise break. N Do not let the starter grip snap back. Guide it slowly back into the housing so that the starter rope can rewind properly. N Continue cranking until the engine runs. 547BA020 KN 547BA021 KN As soon as the engine runs N Press down the throttle trigger lockout and open the throttle - the choke lever moves to the run position F. After a cold start, warm up the engine by opening the throttle several times. WARNING Make sure the carburetor is correctly adjusted. The cutting blades must not move when the engine is idling. Your machine is now ready for operation. Stopping the Engine N Move the stop switch in the direction of 0 - the engine stops - release the stop switch - it springs back to the run position. Other Hints on Starting English Engine does not start in warm start position < N Move the choke lever to g and continue cranking until the engine runs. If the engine does not start N Check that choke lever is in correct position. N Check that there is fuel in the tank and refuel if necessary. N Check that the spark plug boot is properly connected. N Repeat the starting procedure. Engine is flooded N Move the choke lever to F and continue cranking until the engine runs. Fuel tank run until completely dry N After refueling, press the manual fuel pump bulb at least five times - even if the bulb is already filled with fuel. N Set the choke lever to suit the engine temperature. N Now start the engine. Engine stalls in cold start position g or under acceleration. N Move the choke lever to < and continue cranking until the engine runs. HL 56 K 19