Stihl FS 56R Instruction Manual - Page 26

English N Insert the stop pin (7) or offset screwdriver (7) in the hole (8) in the gearbox as far as stop - and apply slight pressure. N Rotate shaft or cutting attachment until the stop pin slips into position and blocks the shaft. Mounting the Cutting Attachment WARNING Wear protective gloves to reduce the risk of direct contact with the sharp cutting edges. Mount only one metal cutting attachment. Check direction of rotation of cutting 1 attachment WARNING Use a deflector that matches the cutting attachment - see "Mounting the Deflector". Fitting the mowing head with screw mounting Keep the supplement sheet for the mowing head in a safe place. N Fit the thrust plate N Turn the mowing head anticlockwise on the shaft (1) as far as it will go N Retain the shaft N Tighten the mowing head NOTICE Remove the tool that was used to block the shaft. Removing the Mowing Head 002BA385 KN 681BA108 KN 1 2 The cutting edges of the grass cutting blade (1) may point in either direction - this cutting attachment must be turned over regularly to reduce one-sided wear. Cutting edges of grass cutting blade (2) must point clockwise. WARNING Direction of rotation is indicated by an arrow on the inside of the deflector. N Retain the shaft N Turn the mowing head clockwise Mounting Metal Cutting Attachment Keep the leaflet and packaging of the metal cutting tool in a safe place. 24 FS 56, FS 56 R, FS 56 C, FS 56 RC