Stihl FC 111 Instruction Manual - Page 22
Mounting the control handle, Fitting the Throttle Cable, Adjusting the Throttle Cable
View all Stihl FC 111 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
0000-GXX-0510-A0 0000-GXX-0511-A0 0000-GXX-0512-A0 English Mounting the control handle 12 14 15 8 11 9 13 10 7 15 14 15 N Place the secured assembly on the handle support (8) with the wing screw at the side nearest the engine. N Push the wing screw into the handle support as far as stop and then screw it down - but do not finally tighten yet. N Line up the handlebar at a right angle to the drive tube - check distance A again. N Tighten down the wing screw firmly. 13 N Take out the screw (9) - the nut (10) remains in the control handle (11). N Push the control handle onto the handlebar (7) until the holes (13) line up - the throttle trigger (12) must point towards the gearbox. N Insert the screw (9) and tighten it down firmly. Fitting the Throttle Cable NOTICE Do not kink the throttle cable or lay it in tight radii - make sure the throttle trigger moves freely. N Push the throttle cable (14) into the retainers (15). Adjusting the Throttle Cable N Check adjustment of throttle cable - see chapter on "Adjusting the Throttle Cable". 20 FS 111, FS 111 R