Sony UP-D895 User Instructions - Page 10

Operation Menu List This section describes the menus displayed as you turn the jog dial. The setting surrounded by indicates the factory setting. Item BEEP CLEAN COMD DIR a) FEED Function Settings To select whether BE: OFF: The operation the operation and tone does not sound. error tones sound [BE: ON]: The operation and error tones sound. BACK: Cancels the setting change and returns to the item selection column. To start head cleaning [CL: OK]: Starts the head cleaning. Be sure to use the supplied cleaning sheet. BACK: Cancels the head cleaning and returns to the item selection column. To select the printer driver to be used CO:895: UP-D895 driver conversion mode. Uses the printer driver for the UPD895. [CO:897]: Uses the printer driver for the UP-D897. BACK: Cancels the setting change and returns to the item selection column. To select whether DI: REV: Starts to print in the top or bottom the reverse direction (from of the screen is to the top of the screen). be printed first [DI: NOR]: Starts to print in the normal direction (from the bottom of the screen). BACK: Cancels the setting change and returns to the item selection column. To select the FE: OFF: Feeds less paper paper feed between prints to conserve method to be used paper, or when printing after printing multiple pictures on the same sheet. More pictures can be printed on one sheet, but because there is so little space between printed picture, feed the desired length of the paper to leave a margin using the FEED button, before cutting the paper. [FE: ON]: Feeds extra blank paper between prints. BACK: Cancels the setting change and returns to the item selection column. Item GAMMA b) (When "ME:S" is selected in "MEDIA," GAMMA is fixed to TONE 1.) IMAGE INFO LOAD MEDIA MENU QTY b) Function Settings To select the tone (density gradation) GA:4: TONE 4 Softest gradation GA:3: TONE 3 Hard gradation [GA:2]: TONE 2 Standard GA:1: TONE 1 Soft gradation BACK: Cancels the setting change and returns to the item selection column. To set the printout IM:NEG: Makes negative to either positive printouts. printout or [IM:POS]: Makes normal negative printout printouts. BACK: Cancels the setting change and returns to the item selection column. To select whether IF:ON: Prints the or not the print information. conditions (such [IF:OFF]: Does not print the as contrast, information. bright, gammas BACK: Cancels the setting and sharpness change and returns to the information) are item selection column. printed under the image To load the LO:3: Loads the "SA:3" registered settings settings registered using the "SAVE" menu item. LO:2: Loads the "SA:2" settings registered using the "SAVE" menu item. [LO:1]: Loads the "SA:1" settings registered using the "SAVE" menu item BACK: Cancels the setting change and returns to the item selection column. To select the type of paper ME:S: Uses the UPP-110S. ME:HD: Uses the UPP110HD. [ME: HG]: Uses the UPP110HG BACK: Cancels the setting change and returns to the item selection column. To print the menu [ME:OK]: Prints the menu settings currently list currently set. selected BACK: Cancels printing and goes back to its item column. To set the print quantity between 1 and 255 You can make one to 255 copies of the same printout. [QT: 1]: Makes one sheet of the printout. BACK: Cancels the setting change and returns to the item selection column. 10 Adjustments and Settings Using the Menu