Sony STR DH700 Operating Instructions - Page 30

Inserting batteries into the remote Insert two R6 (size-AA) batteries in the RM-AAU021 Remote Commander. Observe the correct polarity when installing batteries. 7: Selecting the speaker system You can select the front speakers you want to drive. Be sure to use the buttons on the receiver for this operation. SPEAKERS Notes • Do not leave the remote in an extremely hot or humid place. • Do not use a new battery with old ones. • Do not mix manganese batteries and other kinds of batteries. • Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction. • If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. • When you replace the batteries, the remote buttons may be reset to their factory settings. If this happens, reassign the buttons again (page 96). • When the remote no longer operates the receiver, replace all the batteries with new ones. ?/1 SPEAKERS TONE INPUT SELECTOR PHONES TONE MODE INPUT MODE TUNING MODE TUNING MEMORY/ 2CH/ ENTER A.DIRECT A.F.D. MOVIE MUSIC MASTER VOLUME DISPLAY DIMMER MUTING VIDEO 2 IN AUTO CAL MIC VIDEO L AUDIO R Press SPEAKERS repeatedly to select the front speaker system you want to drive. To select Light up The front speakers connected to the SP A SPEAKERS FRONT A terminals The front speakers connected to the SPEAKERS SURROUND BACK/ BI-AMP/FRONT B terminals SP B* The front speakers connected to both SP A and the SPEAKERS FRONT A terminals SP B* and SPEAKERS SURROUND BACK/BI-AMP/FRONT B terminals (parallel connection) * To select "SP B", set "SB ASGN" to "SPK B" in the System settings menu (page 43). To turn off the speaker output, press SPEAKERS repeatedly until the "SP A" and "SP B" indicators on the display light off. Note You cannot switch the front speaker system by pressing SPEAKERS when the headphones are connected to the receiver. 30US