Sony RHT-G800 Instruction Manual - Page 29

Advanced Settings PLAY RETUR Advanced Settings Programming the remote for TV operation (Input SYNC: Sony TV only) If you connect a Sony TV, follow the steps below to program the remote. The TV input will be selected automatically (Input SYNC). Note • Do not use the HDMI control function while the Input SYNC function is active. For details, see the HDMI CONRTOL Guide of the stand. TV (orange) Input buttons (TV, DVD/ BD, SAT, AUDIO) Number buttons ENT IDE DIS GU TO POTILOSNS N O HOME MENU 1 Press TV (orange) while holding down the input button (TV, DVD/BD, SAT, AUDIO) for the component you want to operate. For example, if you are going to operate a DVD player, press DVD/BD. The input button you pressed flashes. 2 Check the table below for the remote button number corresponding to the TV input jack you have connected to, and press the number. The input button (TV, DVD/BD, SAT, AUDIO) goes off when you press the number button. TV input jack* VIDEO 1 VIDEO 2 VIDEO 3 VIDEO 4 VIDEO 5 VIDEO 6 VIDEO 7 VIDEO 8 COMPONENT 1 COMPONENT 2 COMPONENT 3 COMPONENT 4 HDMI 1 HDMI 2 HDMI 3 HDMI 4 HDMI 5 VIDEO RESET (TV) NONE Remote Button (codes) 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 20 * TV input jack name may differ depending on your TV model. Tip • Press 20 if you do not want to send signals to the TV. 3 Press ENT. The setting is completed after the input button you pressed in step 1 flashes twice. 4 Repeat steps 1 to 3 to program the remote. Notes • An error has occurred when the input button you pressed in step 1 flashes five times. Perform this process from step 1 again. • The two digits entered last are valid. continued 29US