Sony NXL-FR316 Operation Guide - Page 1
Sony NXL-FR316 Manual
![]() |
View all Sony NXL-FR316 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
4-741-570-12 (1) SIGNAL PROCESSING UNIT Operation Manual NXL-FR316 © 2018 Sony Corporation Printed in Japan Before operating the unit, please read this manual thoroughly and retain it for future reference. L-1_4-741-570-11(1)_201803061455_GB_1/30 WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. S-1_4-741-570-11(1)_201803061455_GB_2/30 WARNING This apparatus must be earthed. S-2_4-741-570-11(1)_201803061455_GB_3/30 CAUTION • There is a danger of explosion if a battery other than specified is charged. Do not charge batteries other than the recommended batteries. • When you dispose of the battery or the product, you must obey the law in the corresponding area or country. Do not dispose of the battery or the product in a fire or a hot oven, or mechanically crush or cut the battery. It may explode or cause a fire. • Do not place the battery in a high temperature place, such as under direct sunlight or near fire. It may ignite, explode, or cause a fire. Do not immerse or wet the battery in water or seawater. This may cause an electric shock. S-4C_4-741-570-11(1)_201803061455_GB_4/30 WARNING This unit has no power switch. When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power plug to an easily accessible socket-outlet near the unit. If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power plug. S-5_4-741-570-11(1)_201803061455_GB_5/30 WARNING Using this unit at a voltage other than 120 V may require the use of a different line cord or attachment plug, or both. To reduce the risk of fire or electric shock, refer servicing to qualified service personnel. S-11_4-741-570-11(1)_201803061455_GB_6/30 This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) or electric shock, refer servicing to qualified service personnel. S-11_4-741-570-11(1)_201803061455_GB_6/30 This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. S-14_4-741-570-11(1)_201803061455_GB_7/30 Attention-when the product is installed in Rack: 1. Prevention against overloading of branch circuit When this product is installed in a rack and is supplied power from an outlet on the rack, please make sure that the rack does not overload the supply circuit. 2. Providing protective earth When this product is installed in a rack and is supplied power from an outlet on the rack, please confirm that the outlet is provided with a suitable protective earth connection. 3. Internal air ambient temperature of the rack When this product is installed in a rack, please make sure that the internal air ambient temperature of the rack is within the specified limit of this product. 4. Prevention against achieving hazardous condition due to uneven mechanical loading When this product is installed in a rack, please make sure that the rack does not achieve hazardous condition due to uneven mechanical loading. 5. Install the equipment while taking the operating temperature of the equipment into consideration For the operating temperature of the equipment, refer to the specifications of the Operation Manual. 6. When performing the installation, keep the following space away from walls in order to obtain proper exhaust and radiation of heat. Right, Left : 4 cm (1.6 inches) or more Rear : 10 cm (4 inches) or more S-26E_4-741-570-11(1)_201803061455_GB_8/30 CAUTION For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to the following port: • NETWORK connector S-28B_4-741-570-11(1)_201803061455_GB_9/30 WARNING: THIS WARNING IS APPLICABLE FOR USA ONLY. If used in USA, use the UL LISTED power cord specified below. DO NOT USE ANY OTHER POWER CORD. Plug Cap Parallel blade with ground pin (NEMA 5-15P Configuration) Cord Type SJT, three 16 AWG wires Length Minimum 1.5 m (4 ft 11 in), Less than 4.5 m (14 ft 9 in) Rating Minimum 10 A, 125 V Using this unit at a voltage other than 120V may require the use of a different line cord or attachment plug, or both. To reduce the risk of fire or electric shock, refer servicing to qualified service personnel. WARNING: THIS WARNING IS APPLICABLE FOR OTHER COUNTRIES. 1. Use the approved Power Cord (3-core mains lead) / Appliance Connector / Plug with earthing-contacts that conforms to the safety regulations of each country if applicable. 2. Use the Power Cord (3-core mains lead) / Appliance Connector / Plug conforming to the proper ratings (Voltage, Ampere). If you have questions on the use of the above Power Cord / Appliance Connector / Plug, please consult a qualified service personnel. S-29B_4-741-570-11(1)_201803061455_GB_10/30 This equipment is not suitable for use in locations where children are likely to be present. S-76_4-741-570-11(1)_201803061455_GB_11/30 CAUTION Danger of explosion if battery is incorrectly replaced. When the internal battery needs to be replaced, please contact a qualified service person. Danger of fire or explosion. When you dispose of the battery or the product, you must obey the law in the relative area or country. Do not dispose of the battery or the product into a fire or a hot oven, or mechanically crush or cut the battery. Danger of fire, explosion or electric shock. Avoid operating or storing the product in the following locations. • Extremely hot or cold places (for operating temperature, see Danger of fire, explosion or electric shock. Avoid operating or storing the product in the following locations. • Extremely hot or cold places (for operating temperature, see Installation Manual.) • Locations where corrosive gas or flammable gas is emitted, or where salt damage may occur. S-78_4-741-570-11(1)_201803061455_GB_12/30 For the customers in the U.S.A. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. E-5_4-741-570-11(1)_201803061455_GB_13/30 You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. E-7_4-741-570-11(1)_201803061455_GB_14/30 All interface cables used to connect peripherals must be shielded in order to comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC Rules. E-8_4-741-570-11(1)_201803061455_GB_15/30 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. E-9_4-741-570-11(1)_201803061455_GB_16/30 For the customers in Canada CAN ICES-3 (A)/NMB-3(A) E-12_4-741-570-11(1)_201803061455_GB_17/30 For the customers in Europe This product is intended for use in the following Electromagnetic Environment: E4 (controlled EMC environment, ex. TV studio). E-20_4-741-570-11(1)_201803061455_GB_18/30 WARNING Operation of this equipment in a residential environment could cause radio interference. E-22H_4-741-570-11(1)_201803061455_GB_19/30 For the customers in Europe This apparatus shall not be used in the residential area. E-36_4-741-570-11(1)_201803061455_GB_20/30 경고 S-1_4-741-570-11(1)_201803061455_KR_21/30 경고 S-2_4-741-570-11(1)_201803061455_KR_22/30 S-4C_4-741-570-11(1)_201803061455_KR_23/30 S-76_4-741-570-11(1)_201803061455_KR_24/30 注意 E-29_4-741-570-11(1)_201803061455_KR_25/30 S-4C_4-741-570-11(1)_201803061455_CT_26/30 S-76_4-741-570-11(1)_201803061455_CT_27/30 S-4C_4-741-570-11(1)_201803061455_CT_26/30 S-76_4-741-570-11(1)_201803061455_CT_27/30 For kundene i Norge E-32_4-741-570-11(1)_201803061455_CT_28/30 Dette utstyret kan kobles til et IT-strømfordelingssystem. S-56_4-741-570-11(1)_201803061455_NO_29/30 For the customers in the U.S.A. SONY LIMITED WARRANTY- Please visit http://www.sony.com/psa/ warranty for important information and complete terms and conditions of Sony's limited warranty applicable to this product. For the customers in Canada SONY LIMITED WARRANTY - Please visit http://www.sonybiz.ca/pro/ lang/en/ca/article/resources-warranty for important information and complete terms and conditions of Sony's limited warranty applicable to this product. For the customers in Europe Sony Professional Solutions Europe - Standard Warranty and Exceptions on Standard Warranty. Please visit http://www.pro.sony.eu/warranty for important information and complete terms and conditions. For the customers in Korea SONY LIMITED WARRANTY - Please visit http://bpeng.sony.co.kr/ handler/BPAS-Start for important information and complete terms and conditions of Sony's limited warranty applicable to this product. L-5_4-741-570-11(1)_201803061455_GB_30/30 For the State of California, USA only Perchlorate Material - special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate For the customers in Taiwan only Türkiye'deki müşteriler için AEEE Yönetmeliğine Uygundur Overview This product is a bridge device for transferring SDI input/output signals on a 4K live production system via a network. Up to 16 optional boards that are 3 rack units in size can be mounted in the unit. Parts Identification Front 1 STATUS indicator For details, see the "Status Indicator" section. 2 BEACON indicator This is blinks blue in sync with the beacon lamp of any optional board that is installed on the unit. 3 Front panel LED This lights blue when the unit is turned on (depending on settings).
![](/manual_guide/products/sony-nxlfr316-operation-guide-04727c6/1.png)