Sharp XG-P560W XG-P560W Setup Manual - Page 43

Stack Projection 6 Connect the COMPUTER/COMPO- NENT1 terminal on the projector 1 to the RGB output terminal on the computer using the RGB cable. (See page 24 on the projector operation manual.) 7 Connect the MONITOR OUT (FOR COMPUTER/COMPONENT1, 2) terminal on the projector 1 to the COMPUTER/COMPONENT1 terminal on the projector 2 using an RGB cable. (See page 27 on the projector operation manual.) 8 Connect the LAN terminal on the projector 1 to the LAN terminal on the projector 2 using a commercially available LAN cable (UTP cable, Category 5, cross-over type). 9 Turn on the projectors first, then turn on the computer. Note • When connecting an RGB cable to the projector 2, use the input terminal that has the same number as the projector 1. (COMPUTER/COMPONENT1 terminal, in this case) Application When inputting multiple image sources, refer to the example below. COMPUTER/COMPONENT2 terminal COMPUTER/COMPONENT1 terminal Projector 1: Master MONITOR OUT (FOR COMPUTER/ COMPONENT1, 2) terminal RGB cable COMPUTER/COMPONENT1 terminal Projector 2: Slave RGB cable LAN terminal VIDEO terminal Computer LAN cable (cross-over type) LAN terminal 5BNC to mini D-sub 15 pin cable VIDEO terminal Computer Projector 1 Master Set Inputs COMPUTER1 ON COMPUTER2 ON DVI OFF HDMI OFF VIDEO ON S-VIDEO OFF Projector 2 Slave Set Inputs COMPUTER1 ON COMPUTER2 OFF DVI OFF HDMI OFF VIDEO ON S-VIDEO OFF Composite video cable Distributor Video equipment -43