Sharp XG-C68X XG-C58X , XG-C68X Operation Manual - Page 99
incorrect operation or interference. If this should happen, unplug the projector and plug it
![]() |
View all Sharp XG-C68X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Problem Pict in Pict does not work. The projector cannot be turned on or put into the standby mode using the ON or STANDBY button on the projector. Picture is green on INPUT 1 or 2 COMPONENT. Picture is pink (no green) on INPUT 1 or 2 RGB. The lamp does not light up even after the projector turns on. The lamp suddenly turns off during projection. Picture is too bright and whitish. The VOLUME buttons on the projector do not work. A response code cannot be received when the projector was attempted to be controlled using RS-232C commands from a computer during standby. Check • The signal in INPUT 1 or 2 is set to a resolution that exceeds SXGA. • The signal in INPUT 1 or 2 is sending Component signals 480I, 480P, 540P, 576I, 576P, 720P, 1035I or 1080I. • The signal in INPUT 1 or 2 is set to interlace mode using RGB signals. • The Keylock level is set. If the Keylock level is set to Level B, all the buttons are locked. If the Keylock level is set to Level A, only the INPUT and VOLUME buttons are functional. • Change the input signal type setting. • The lamp indicator is illuminating in red. Replace the lamp. • Picture adjustments are incorrectly set. The VOLUME buttons do not work when: (try the VOL+/- on the remote control) • when the menu is displayed • when the lens menu is displayed • when Pict in Pict is working • during Enlarge (More than double size) • a dot by dot screen resolution larger the panel resolution • In the case of transmitting RS-232C commands from a computer during standby, it takes a maximum of 30 seconds for the computer to receive the response code. Set the response code waiting time of the computer to 30 seconds or more. Page 57 72 46 83 46 - 89 This projector is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the projector and plug it in again after more than 5 minutes. Appendix -95
![](/manual_guide/products/sharp-xgc58x-xgc58x-xgc68x-operation-manual-6f1f514/99.png)