Sharp XG-C455W Owners Manual for XG-C455W - Page 25
Connecting to a Computer
View all Sharp XG-C455W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting to a Computer Before connecting, ensure the power cord of the projector from the AC outlet is unplugged, and that the devices to be connected are turned off. After making all connections, turn on the projector and then the other devices. When connecting a computer, ensure that it is the last device to be turned on after all the connections are made. Ensure the operation manuals of the devices to be connected have been read before making connections. When connecting with the RGB cable (Connecting to COMPUTER/COMPONENT 1 or 2: The illustration shown below is for the former.) Supplied accessory RGB cable Computer To audio output terminal To RGB output terminal To COMPUTER/ COMPONENT 1 input terminal To AUDIO input terminal RGB cable * ø3.5 mm stereo or mono audio cable (commercially available or available as Sharp service part QCNWGA038WJPZ) * When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable. Note • See page 65 "Computer Compatibility Chart" for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions to not work. • A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Macintosh Dealer. • Depending on the computer you are using, an image may not be projected unless the computer's external output port is switched on. (e.g. Press "Fn" and "F5" keys simultaneously when using a SHARP notebook computer). Refer to the specific instructions in your computer's operation manual to enable your computer's external output port. Connections -23