Sharp PN-HY431 Quick Start Setup Guide - Page 7

ENGLISH Supplied Components If any component should be missing, please contact your dealer.  Liquid Crystal Display Monitor: 1  Remote control unit: 1  Power cord: 1  Remote control unit battery: 2  Setup Manual (this manual): 1  Cable clamp: 2  Logo sticker: 1  USB flash drive cover: 1  USB flash drive cover fixing screw: 2 * For environmental protection! Do not dispose of batteries in household waste. Follow the disposal instructions for your area. Specifications Model PN-HS551 PN-HY551 PN-HS501 PN-HY501 PN-HS431 PN-HY431 Power requirement AC 100 - 240 V, AC 100 - 240 V, AC 100 - 240 V, AC 100 - 240 V, AC 100 - 240 V, AC 100 - 240 V, 2.1 A, 1.8 A, 1.7 A, 1.3 A, 1.6 A, 1.2 A, 50/60 Hz 50/60 Hz 50/60 Hz 50/60 Hz 50/60 Hz 50/60 Hz Operating temperature * 32°F to 104°F (0°C to 40°C) Operating humidity 20% to 80% (no condensation) Power consumption 190 W 150 W 110 W 140 W 100 W Dimensions inch (mm) Approx. 48-7/8 (W) x (excluding protrusions) 2-1/2 (D) x 28-1/16 (H) (1241.8 x 63.5 x 712.6) Approx. 44-7/16 (W) x 2-1/2 (D) x 25-9/16 (H) (1128.4 x 63.5 x 649) Approx. 38-5/16 (W) x 2-1/2 (D) x 22-1/8 (H) (973 x 63.5 x 561.2) Weight lbs. (kg) Approx. 39.7 (18.0) Approx. 33.1 (15.0) Approx. 25.4 (11.5) * W hen using the monitor laying flat on a surface (when the monitor is tilted more than 20 degrees upward or downward from the perpendicular in relation to a level surface), use the monitor at a temperature between 32°F (0°C) to 86°F (30°C). Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Preparing the Remote Control Unit 1. Place your finger on the part marked with the ▲, and then pull the cover off. 2. See the instructions in the compartment and put in the batteries (R03 or LR03 ("AAA" size) x 2) with their plus (+) and minus (-) sides oriented correctly. 3. Close the cover. 5E