Sharp BP-50M55 Operating Manual - Page 1002
Sided Copying Does Not Take Place, Rotate Copy Does Not Work, Enlarge/reduce Does Not Work
View all Sharp BP-50M55 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1002 highlights
TROUBLESHOOTING►GENERAL PROBLEMS 2-SIDED COPYING DOES NOT TAKE PLACE Check Does the paper type setting of the selected tray specify a type of paper that cannot be used for 2-sided copying? Are you using a special size or type of paper? Are you copying using settings that do not allow 2-sided copying? Solution ■ Check "Paper Tray Settings" in the setting mode. "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job] Check the [Tray Settings] in the home screen. Tap the selected tray, and in the screen that appears, tap the [Paper Property] key. If the [Disable Duplex] checkbox in the paper properties screen is , the tray cannot be used for duplex printing. Change the paper type to a type that can be used for duplex printing. ■ For the paper types and sizes that can be used for two-sided copying, read "SPECIFICATIONS" in Start Guide. ■ 2-Sided Copy can generally be combined with other modes as required, however, some combinations are not possible. If a prohibited combination is selected, a message will appear in the touch panel. ROTATE COPY DOES NOT WORK Check Did you select the copy ratio manually? Are you copying using settings that do not allow rotate copying? Is "Rotation Copy Setting" disabled in the setting mode? Solution ■ Use automatic ratio selection when copying. ■ Rotate copying can generally be combined with other modes as required, however, some combinations are not possible. If a prohibited combination is selected, a message will appear in the touch panel. ■ Check with your administrator. If you are the administrator, enable [Rotation Copy Setting]. Select [System Settings] → [Copy Settings] → [Condition Settings] → [Rotation Copy Setting] → [Rotation Copy] in "Settings". ENLARGE/REDUCE DOES NOT WORK Check Are the original, paper, and ratio settings correct? Solution ■ Check if the original size that appears on the screen is correct. After that, check if the correct paper is selected. Tap the [Ratio] key and then tap the [Auto Image] key. The appropriate ratio for the original and paper will appear. 10-23