Sharp BP-50M45 Software Setup Guide - Page 15
Changing the port
View all Sharp BP-50M45 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Table of contents Windows / Select the software to be installed Installing the printer driver / PC-Fax driver (common procedure) Standard installation / Advanced installation / Custom installation Changing the port 1 Click the [Start] button, select [Settings] → [Device] → [Devices and Printers]. In Windows 11, click the [Start] button, select [Settings] →[Bluetooth & devices] → [Printers & scanners]. In Windows 8.1/Windows Server 2012, right-click the [Start] button, select [Control Panel] → [View devices and printers] (or [Devices and Printers]). 2 Open the printer properties window. (1) Right-click the printer driver icon of the machine. (2) Select [Printer properties]. 3 Adding or changing a port. (1) Click the [Ports] tab. (2) Click the [Add Port] button. • To change to an existing port, select the port from the list and click the [Apply] button. 4 Select the port type and click the [New Port] button. • Standard TCP/IP Port This is the standard printer port provided by the operating system. (1) Click the [Next] button. (2) Enter the machine's IP address in [Printer Name or IP Address] and click the [Next] button. (3) Click the [Finish] button. • SC2 TCP/IP Port Use this port if you will use Tandem Print on an IPv4 network. (1) Enter the machine's IP address. (2) Make sure that [LPR] is selected. (3) Make sure that [lp] is entered. (4) Click the [OK] button. • SC-Print2005 Port If the printer driver is installed using a "Custom installation" with "Use an IPP or IPPS port" selected, the "SC-Print2005 Port" is added. Follow the on-screen instructions. • The "SC2 TCP/IP Port" is added when the printer driver is installed using a "Custom installation" with "Specify the MFP IP address" or "Search for MFP" selected. • The "SC2 TCP/IP Port" cannot be used if the machine is connected to an IPv6 network. 5 Click the [Close] button in the screen of step 4. 6 Click the [Apply] button in the screen of step 3. • When using a port created using "Standard TCP/IP Port", in the screen that appears after you click the [Configure Port] button in the screen of step 3, make sure the [SNMP Status Enabled] checkbox is not selected ( ). If the [SNMP Status Enabled] checkbox is selected ( ), it may not be possible to print correctly. Related topics • Windows / Select the software to be installed (P. 3) • Install the driver using an existing port (P. 12) Troubleshooting • The software cannot be installed (P. 22) • How to check the IP address of this machine (P. 22) • Problem with Windows (P. 23) 15