Sennheiser SKP 100 G3 Instructions for Use - Page 7
Putting the plug-on transmitter into, operation
![]() |
View all Sennheiser SKP 100 G3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Putting the plug-on transmitter into operation Putting the plug-on transmitter into operation Inserting the batteries/accupack For powering the plug-on transmitter, you can either use two 1.5 V AA size batteries or the rechargeable Sennheiser BA 2015 accupack (see "Accessories" on page 20). ̈ Slide the battery compartment cover ¸ in the direction of the embossed arrow and open the cover ¸. ¸ ̈ Insert the two batteries or the accupack as shown below. Please observe correct polarity when inserting the batteries/accupack. ¸ ̈ Close the battery compartment. The battery compartment cover ¸ locks into place with an audible click. Charging the accupack ̈ Remove the BA 2015 accupack. ̈ Insert the BA 2015 accupack into the L 2015 charger (see "Accessories" on page 20). The L 2015 charger can only charge the BA 2015 accupack. Standard batteries (primary cells) or individual rechargeable battery cells cannot be charged. Plugging the plug-on transmitter onto a microphone ̈ Plug the microphone's XLR-3M socket onto the transmitter's XLR-3F socket ³. ³ · ̈ Tighten the locking ring · in the direction of the arrow. The transmitter uses the microphone body as an antenna - therefore microphones with a metal casing should be used for best signal transmission. 6
![](/manual_guide/products/sennheiser-skp-100-g3-instructions-use-242e2e2/7.png)