Sennheiser HE 1 Instruction manual HE 1 - Page 47
Restoring the factory default settings, to switch the HE 1 on.
View all Sennheiser HE 1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
1 INPUT OPTICAL USB COAXIAL OFF UNBALANCED BALANCED CROSS FEED OFF LOW HIGH 2 OUTPUT PHONES LINE BOX CONTROL BOX 1 O/C BOX 2 O/C Servicing the HE 1 | Restoring the factory default settings Restoring the factory default settings To reset all individually stored signal levels of the INPUT audio inputs and OUTPUT audio outputs and the last settings used to the factory default settings: 1. Set the power switch to OFF to switch the HE 1 off and wait until the status LED goes off (up to 30 seconds). 2. Simultaneously press the - and the + button on the remote control and then set the power switch to ON to switch the HE 1 on. The status LED flashes green. All settings are reset to the factory default settings. Once the process is completed, the status LED lights up red. The HE 1 is switched off (standby). When restoring the factory default settings, make sure to point the remote control at the remote control sensor located on the front bottom of the amplifier. Otherwise the amplifier switches on normally. ON 45