Schwinn Voyageur Tandem Schwinn Owner's Manual - Page 44
Derailleur
View all Schwinn Voyageur Tandem manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Freewheel Guide Pulley Tension Pulley High gear adjustment screw Low gear adjustment screw Outer side of top gear Pulley adjustment screw Adjustment screws SIS cable adjuster 3.42 DERAILLEUR Although the front and rear derailleurs are initially adjusted at the factory, you will need to inspect and readjust both before riding the bicycle. Rear Derailleur Begin by shifting the rear shifter to largest number indicated and place the chain on the smallest sprocket. Adjust the High limit screw so the guide pulley and the smallest sprocket are lined up vertically. Reconnect the cable, pull out any slack, and retighten the anchor bolt securely. Shift through the gears, making sure each gear achieved is done quietly and without hesitation. If necessary, use the barrel adjuster to fine tune each gear by turning it the direction you want the chain to go. For example, turning clockwise will loosen the cable tension and move the chain away from the wheel, while turning counter-clockwise will tighten cable tension and direct the chain towards the wheel. Shift the rear shifter to the gear one and place the chain on the largest cog. Adjust the Low limit screw in quarter turn increments until the guide pulley and the largest cog are aligned vertically. Again, shift through each gear several times, checking that each gear is achieved smoothly. It may take several attempts before the rear derailleur and cable is adjusted properly. (Fig. 3.42, 3.43) Ensure all bolts are secured tightly and the chain does not fall off in either direction. ASSEMBLY Barrel adjuster 3.42 44 ©2010