Schwinn Mist Schwinn Owner's Manual - Page 47
Flat Brace, Training Wheel Stabilizer Bracket
View all Schwinn Mist manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Flat Brace Inn er axle Flat w heel bra ce It is very important to check the training wheel connection to the bicycle. Failure to properly tighten may cause the training wheel to dislodge. Please contact Pacific Cycle Service with any questions. Brace stabilizer washer Axle nut Remove the outer axle nut and washer from the rear wheel axle. Place the flat wheel brace onto the axle. Next place the brace stabilizer washer onto the axle and align it so that the notch fits into the rear frame drop out. Replace the washer and axle nut. Tighten the axle nut securely, making sure that the wheel brace stays in the proper vertical position. The elongated hole on the wheel brace allows the training wheel height to be adjusted for proper fit. (Fig. 3.49) Training wheel Inner axle nut DO NOT REMOVE 3.49 Stabilizer bracket Washer Axle nut Training Wheel Stabilizer Bracket Remove the outer axle nut and washer from the rear wheel axle. Insert the wheel brace into the stabilizer bracket so that the forked end of the stabilizer bracket faces in. Slide assembly onto the rear axle so that the forked end hooks around the chain stay of the bicycle. Replace the axle nut and washer, secure tightly. The elongated hole on the brace allows for raising and lowering the training wheel to the proper height. (Fig. 3.50) NOTICE: Not all bicycles will accept training wheels. If your bike did not come stock with training wheels, please call Pacific Cycle to help determine if after-market training wheels can be attached. ASSEMBLY Wheel brace Training wheel 3.50 46 ©2010