Sanyo XF40 Instruction Manual, PLC-XF40 - Page 14

CONNECTING PROJECTOR CONNECTING TO COMPUTER Cables used for connection (✽ = Cables are not supplied with this projector.) • VGA Cable (HDB 15 pin) • Control Cable for PS/2 port, Serial port, or ADB port • MAC/VGA Adapter, DVI/VGA Adapter • DVI Cable • BNC Cable (BNC x 5) ✽ • Audio Cables (RCA x 2) ✽ NOTE : When connecting cable, power cords of both a projector and external equipment should be disconnected from AC outlet. Turn a projector and peripheral equipment on before computer is switched on. IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA / SXGA/UXGA) Desktop type Laptop type 14 Monitor Output BNC Cable ✽ Monitor Output Monitor Output Audio Output Serial port PS/2 port ADB port MAC/VGA Adapter Set slide switches following chart below. DVI Cable Audio Cable (stereo) ✽ Control Cable Control Cable Control Cable for Serial Port for PS/2 Port for ADB Port Terminal Terminal Terminal VGA Cable DVI/VGA Adapter Terminals of a Projector INPUT 1 INPUT 2 SERIAL PORT IN SERIAL PORT OUT R/C JACK USB AUDIO OUT R L RESET (MONO) DVI R/Pr G/Y B/Pb H/HV V VIDEO/Y C S-VIDEO ANALOG RGB AUDIO CONTROL PORT R L (MONO) AUDIO R L CONTROL PORT (MONO) AUDIO R L (MONO) AUDIO CONTROL PORT R L (MONO) INPUT 3 INPUT 4 AUDIO OUT Audio Cable (stereo) ✽ Switches of MAC/VGA Adapter Use one of these Control Cables corresponding with terminal of your computer. MAC/VGA ADAPTER ON OFF ON DIP 123456 Audio Input External Audio Equipment Audio Amplifier Audio Speaker (stereo) Set switches as shown in table below depending on RESOLUTION MODE that you want to use before your turn on a projector and computer MODE SWITCHES 1 2 3 4 5 6 13"MODE (640 x 480) ON ON OFF OFF OFF OFF 16"MODE (832 x 624) OFF ON OFF ON OFF OFF 19"MODE (1024 x768) OFF ON ON OFF OFF OFF 21"MODE (1152 x 870) ON ON ON ON OFF OFF