Sanyo PLC-XU51 Owners Manual - Page 52
Lamp Replacement - bulb
View all Sanyo PLC-XU51 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Maintenance and Cleaning Lamp Replacement When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the lamp with a new one promptly. Top Control POWER This indicator lights yellow when the life of the projection lamp draws to an end. SELECT WARNING LAMP REPLACE VOLUME + CAUTION Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp. 1 Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes. 2 Loosen the screw with a screwdriver, and remove the lamp cover. 3 Loosen 2 screws of the lamp with a screwdriver and pull out the lamp by grasping the handle. 4 Replace the lamp with a new one and tighten the 2 screws back into position. Make sure that the lamp is set properly. Replace the lamp cover and tighten the screw. 5 Connect the AC power cord to the projector and turn on the projector. 6 Reset the Lamp replace counter. See "Lamp Replace Counter" on the next page . Lamp Cover Screw Lamp Screw Screw Handle ORDER REPLACEMENT LAMP Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. ● Model No. of your projector : ● Replacement Lamp Type No. : PLC-XU56/ PLC-XU51/ PLC-SU51 POA-LMP55 (for PLC-XU51) (Service Parts No. 610 309 2706) POA-LMP65 (for PLC-XU56/PLC-SU51) (Service Parts No. 610 307 7925) 52