Sanyo PLC-WM5500/L RS232C Basic - Page 11

PLC-WM5500/WM5500L Basic Serial Command Functional Specifications 6.4 Operation Requirements 6.4.1 In the following status of projector, Available Functional Execution Commands are limited. Projector Status Available Functional Execution Commands Standby Mode Countdown in process C00: POWER ON C00: POWER ON → Countdown is terminated C01: POWER OFF C02: POWER OFF → Countdown is terminated C46: ZOOM C47: ZOOM + C4A: FOCUS C4B: FOCUS + C5D: LENS SHIFT UP C5E: LENS SHIFT DOWN C5F:LENS SHIFT LEFT C60:LENS SHIFT RIGHT Cooling Down in process Cooling Down due to Abnormal Temperature Abnormal Temperature Status Abnormal Power Status Abnormal Filter Status Power-Save Cooling Down in process Power Save Status Cooling Down in process after OFF operation due to Lamp Failure Input button Mode2 / Mode3 setting When ZOOM+/-, FOCUS +/-, LENS SHIFTUP/ DOWN/LEFT/RIGHT are executed during Countdown is in process, POINTER UP/DOWN(C3C/C3D) become effective, and ZOOM/FOCUS/LENS SHIFT become enable to control by POINTER UP/DOWN. *Pointer Command(C3A/CA3B/C3C/C3D) NONE (No Execution) NONE (No Execution) NONE (No Execution) NONE (No Execution) NONE (No Execution) NONE (No Execution) C00: POWER ON C01: POWER OFF NONE (No Execution) Although transmit Input source commands, Input search does not operate. Note) in above status, the projector returns [ACK] [CR] even if it receives the other command. 6.4.2 Functional Execution Commands are invalid when projector is in standby and "Eco" mode selected in Standby mode menu. 11/28