SanDisk SDCFS-128-A10 Product Manual - Page 22
Table 3-4, Signal Description
UPC - 619659022624
View all SanDisk SDCFS-128-A10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Interface Description SanDisk CompactFlash Card OEM Product Manual The SanDisk CompactFlash Memory Card signals are described in Table 3-4. Table 3-4 Signal Description Signal Name Dir. Pin Description A10-A0 I 8, 10, 11, 12, 14, These address lines, along with the -REG (PC Card Memory Mode) (PC Card I/O Mode) 15, 16, 17, 18, 19, 20 signal, are used to select the following: I/O port address registers within the card, memorymapped port address registers within the card, a byte in the card's information structure and its configuration control and status registers. A2-A0 (True IDE Mode) I 18, 19, 20 In True IDE Mode only A[2:0] is used to select one of eight registers in the Task File. A10-A3 (True IDE Mode) In True IDE Mode these remaining address lines should be grounded by the host. BVD1 I/O (PC Card Memory Mode) 46 This signal is asserted high as the BVD1 signal since a battery is not used with this product. -STSCHG (PC Card I/O Mode) The Status Changed signal is asserted low to alert the host to changes in the RDY/-BSY and Write Protect states, while the I/O interface is configured. Its use is controlled by the Card Config. and Status Register. -PDIAG (True IDE Mode) In the True IDE Mode, this input/output is the Pass Diagnostic signal in the master/slave handshake protocol. BVD2 I/O (PC Card Memory Mode) 45 This output line is always driven to a high state in Memory Mode since a battery is not required for this product. -SPKR (PC Card I/O Mode) This output line is always driven to a high state in I/O Mode since this product does not support the audio function. -DASP (True IDE Mode) In the True IDE Mode, this input/output is the Disk Active/Slave Present signal in the master/ slave handshake protocol. -CD1, -CD2 O (PC Card Memory Mode) (PC Card I/O Mode) (True IDE Mode) 26, 25 These Card Detect pins are connected to ground on the card. They are used by the host to determine if the card is fully inserted into its socket. -CE1, -CE2 I (PC Card Memory Mode) (PC Card I/O Mode) 7, 32 The Card Enable input signals are used both to select the card and to indicate to the card whether a byte or a word operation is being performed. -CE2 always accesses the odd byte of the word. -CE1 accesses the even byte or the Odd byte of the word depending on A0 and -CE2. A multiplexing scheme based on A0, -CE1, -CE2 allows 8 bit hosts to access all data on D0-D7. -CS0, -CS1 (True IDE Mode) In True IDE Mode, -CS0 is the chip select for the Task File registers while -CS1 is used to select the Alternate Status Register and the Device Control Register. -CSEL I (PC Card Memory Mode) (PC Card I/O Mode) 39 This signal is not used for PC Card Memory Mode or PC Card I/O Mode. 02/07, Rev. 12.0 3-4 © 2007 SanDisk Corporation