Samsung WA8600 User Manual - Page 27
Step 6, Step 7
View all Samsung WA8600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation STEP 6 Running a test cycle Run a test cycle as follows to check if your washer is properly installed. 1. Load about 6 pounds of laundry into the tub. 2. Press Power to turn on your washer. 3. Select Rinse+Spin by press the Cycle Selector. 4. Press and hold Start/Pause to start the test cycle. 5. The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and should drain well during the spin cycle. NOTE If water leaks while water is being supplied or drained, check the water connections. Refer to the "STEP 2 Connecting the water supply hose" section on page 21 for instructions. NOTE If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP 4 Leveling your washer" section on page 25 for instructions. STEP 7 Calibration Mode Your Samsung washer detects the laundry weight automatically. For more accurate weight detection, please run Calibration Mode after the installation. To run Calibration Mode, follow these steps: 1. Remove laundry or any contents in the machine. 2. Press and hold Temp. and Delay End simultaneously for at least 3 seconds when the power is turned on. 3. Press and hold Start/Pause to activate Calibration Mode. 4. The pulsator rotates clockwise and counterclockwise approximately 1 minute. 5. When Calibration Mode is finished, "0" appears on the display, and the washer automatically turns off. The washer is now ready for use. 8",@8 JOEE English 27