Samsung VR30T85513W/AA User Manual - Page 9

Operation and maintenance English A. Installation NOTE • Install the Clean Station in a place where the floor and wall are level. • If the power cord is too long for the installation environment, coil the power cord around the cable management post, then put it in the fixing groove at the rear of the Clean Station. • If you reinstall the Clean Station to a new position of 45 degrees or 1 m (3.3 ft) or more from the previous installed place, recreate the map using the SmartThings App. (If you use the existing map, some places may not be cleaned.) B. Using the Jet Bot B-1 Charging the Jet Bot Charging • Open the upper cover of the Jet Bot and remove the white gasket. • Remove the yellow gasket attached to the power switch at the side of the Jet Bot and press the power switch to turn the Jet Bot on. • Place the Jet Bot on the Clean Station manually to start charging. - When the Jet Bot starts charging, the Status Indicator of the Clean Station turns white and after 1 minute, the Status Indicator turns off automatically. (Charging continues though the Status Indicator has turned off.) • Check the charging status. - When charging starts, the Status Indicator of the Jet Bot turns on (red, orange, or yellow depending on charging progress), it rises gradually, and changes to green when the charging is complete. Docking (Recharging) • You can return the Jet Bot to the Clean Station while cleaning to recharge. - Press the [ ] on the Jet Bot or use the SmartThings App to select the recharging function. B-2 Starting cleaning • Press the [ ] on the Jet Bot to start cleaning in Auto Clean. • Press the [ ] on the Jet Bot to stop operation while cleaning. - When pressing the [ ], the Jet Bot returns to the Clean Station and starts charging. C. Cleaning the Jet Bot Before maintenance work, you should turn off the power switch at the side of the Jet Bot. C-1 Emptying and cleaning the Dustbin • Remove the dust on the filter and the Dustbin, clean them with water, and dry completely in the shade. C-2 Cleaning the brush C-3 Cleaning the Sensor Window • Wipe the Sensor Window with a soft cloth. C-4 Cleaning the Driving Wheel C-5 Cleaning the Spin Brush • If curl or deformation occurs, Cover the Spin Brush with a hot steamed cloth for 10 seconds, then wipe the Spin Brush. D. Cleaning the Clean Station Before cleaning the Clean Station, unplug the power cord from the electrical outlet. D-1 Replacing the Dust Bag D-2 Cleaning the Fine dust Filter • Do not clean the Fine dust Filter with water. NOTE • To maintain the best performance of the Fine dust Filter, replace the filter at least once a year. • For detailed methods of use and cleaning, refer to the QR code. English 9