Samsung NZ36K7570RG/AA Installation Guide - Page 7
Installation instructions, Install cooktop, STEP 1
View all Samsung NZ36K7570RG/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installation instructions Before you make the electrical connection: To properly install your cooktop, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. • A 3-wire or 4-wire, single phase, 208 or 240 volt AC, 60-Hz. • Use the chart below to determine the minimum recommended dedicated circuit protection. kW Rating (240 V) ≤4.8 kW 4.9 kW - 7.2 kW 7.3 kW - 9.6 kW 9.7 kW - 12.0 kW kW Rating (208 V) ≤4.1 kW 4.3 kW - 6.2 kW 6.3 kW - 8.3 kW 8.4 kW - 10.4 kW Recommended Circuit Size (Dedicated) 20 Amp 30 Amp 40 Amp 50 Amp NOTE • The cooktop is rated 240 volt. Some models have a neutral (white) wire. • The cooktop should be connected directly to the junction box through flexible, armored or nonmetallic sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit breaker box should be connected directly to the junction box. • Locate the junction box to allow as much slack as possible between the junction box and the cooktop so that the cooktop can be moved if servicing becomes necessarry in the future. • Do not cut the conduit. Use the length of conduit provided. • A UL listed or CSA approved conduit connector is necessary at each end of the power supply cable (at the cooktop and at the junction box). A listed conduit connector is already provided at the cooktop. • If the house has aluminum wiring, follow the procedure below: 1. Connect a section of solid copper wire to the pigtail leads. 2. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. Install cooktop STEP 1 Prepare installation Decide on the final location for the cooktop. Avoid drilling or cutting into house wiring during installation. Bottom of Cooktop 01 Using 2 or more people, place the cooktop upside down on a covered Foam Tape surface using the foam end posts from the packaging. Make sure that the knobs are not resting on the foam. 02 The foam strip helps avoid damage to the underside of the cooktop glass from Cooktop Glass debris and helps the cooktop sit flat on uneven counters. STEP 2 Place cooktop Cooktop Insert the cooktop centerd into the cutout opening. Make sure the cooktop is parallel to the front edge of the countertop. Make final check that all required clearances are met. English 7 Installation instructions Radiant Install_NZ30K7570R_DG68-00825A-07_EN+MES+CFR.indb 7 11/22/2019 2:45:12 PM