Samsung NZ36K6430RG/AA Installation Guide - Page 8

Installation instructions STEP 3-1 Bracket Guide Installing -Main The bracket Guide can be installed after cooktop is placed into the cutout. Bottom of Cooktop 1. Attach bracket guide to bottom of cooktop and side of wall. 2. Adjust to match hole of bracket and bottom of cooktop. 3. Tighten screw enough to hold bracket in place when cooktop is placed in cutout. 4. Using 2 or more people, turn the cooktop right side up and place in cutout. M 4 L10 screw M 4 L16 screw NOTE Make sure that the front edge of the cooktop is parallel to the front edge of the countertop. If repositioning is needed, lift entire cooktop up from cutout to avoid scratching the countertop. STEP 3-2 Alternative Bracket Guide Installing Cooktop Countertop UNC 243/16 L75 screw M4 X L10 screw 1. Attach bracket guide to bottom and select bracket location. 2. Tighten screw bracket guide to base of cooktop. 3. Install UNC 243/16 L75 screw until bracket touches the bottom of the countertop. Make electrical connection This cooktop is manufactured with ground wire (bare or green) connected to the cooktop frame connect the cooktop cable to the junction box through the UL listed or CSA approved conduit connector. Electrical Connection Options If your home has: 4-wire direct And you will be connecting to : Afused disconnect or circuit breaker box Go to section: 4-Wire Cable from Power supply to 3-Wire Cable from Cooktop 3-wire direct Afused disconnect or circuit breaker box 3-Wire Cable from Power supply to 3-Wire Cable from Cooktop Installation instructions 8 English Radiant Install_NZ30K7570R_DG68-00825A-07_EN+MES+CFR.indb 8 11/22/2019 2:45:12 PM