Samsung NZ30K7880UG/AA Installation Guide - Page 3

Important safety information Installation requirements For your Safety This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a 40A circuit breaker or a time delay circuit breaker as noted on name plate. We recommend you have the electrical wiring and hookup of your cooktop connected by a qualified electrician. After installation, have the electrician show you where your main cooktop disconnect is located. The cooktop conduit wiring is approved for copper wire connection only, and if you have aluminum house wiring, you must use special UL approved connectors for joining copper to aluminum. WARNING If the information in this manual is not followed exactly, a fire or electrical shock may result causing property damage, personal injury, or death. WARNING Before beginning the installation, switch the power off at the service panel and lock the service disconnecting switch to prevent power from being switched on accidentally. When the service disconnecting switch cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. WARNING This appliance must be properly grounded. Tool and parts Tools you will need Pencil Phillips Head Screwdriver Ruler or Straightedge Safety Glasses Saber Saw 1/8" Drill Bit & Electric or Hand Drill Parts needed • A UL listed or CSA approved connector for 1/2" (1.3 cm) diameter conduit\ • UL listed wire connectors Check local codes. Check existing electrical supply. See the "Electrical requirements" section. It is recommened that all electrical connections be mafe by a licensed, qualified electrical installer. Parts included Induction Install_NZ30K7880U_NZ36K7880U_DG68-00827A-05_EN+MES+CFR.indb 3 6 screw (M4L10 2 ea, M4 L16 2 ea, UNC 243/16 L75 2 ea) Bracket Guide: 2ea Foam Tape English 3 2018-07-31 4:10:07