Ryobi TS1143L User Manual 9 - Page 20
Squaring The Blade To The Miter Table
View all Ryobi TS1143L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
ASSEMBLY SQUARING THE BLADE TO THE MITER TABLE See Figures 22 - 24. Unplug the saw. Pull the saw arm all the way down and engage the lock pin to hold the saw arm in transport position. Loosen the miter lock handle approximately one-half turn. Depress the miter lock plate and rotate the miter table until the pointer on the control arm is positioned at 0°. Release the miter lock plate and securely tighten the miter lock handle. Loosen bevel lock knob and set saw arm at 0° bevel (blade set 90° to miter table). Tighten bevel lock knob. Place a combination square against the miter table and the flat part of saw blade. Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth. Rotate the blade by hand and check the blade-to-table alignment at several points. The edge of the square and the saw blade should be parallel as shown in figure 22. If the top or bottom of the saw blade angles away from the square as shown in figures 23 and 24, adjustments are needed. Loosen the lock nut securing positive stop adjustment screw. Also loosen bevel lock knob. Adjust positive stop adjustment screw to bring saw blade into alignment with the square. See "Positive Stop Adjustment" in the Adjustments section. Retighten bevel lock knob. Next, retighten lock nut securing the positive stop adjustment screw. Recheck blade-to-table alignment. Note: The above procedure can be used to check blade squareness of the saw blade to the miter table at both 0° and 45° angles. The saw has two scale indicators, one on the bevel scale and one on the miter scale. After squaring adjustments have been made, it may be necessary to loosen the indicator screws and reset them to zero. BEVEL LOCK KNOB miter FENCE Blade Miter lock plate Combination SQUARE MITER TABLE Miter lock Handle CORRECT VIEW OF Blade SQUARE WITH Miter Table Fig. 22 BEVEL LOCK KNOB miter FENCE Blade Miter lock plate Combination SQUARE MITER TABLE Miter lock Handle VIEW OF Blade NOT SQUARe WITH Miter Table, ADJUSTMENTS ARE REQUIRED Fig. 23 BEVEL LOCK KNOB miter FENCE Blade Miter lock plate Miter SCALE INDICATOR SCREW scale indicator Combination SQUARE MITER TABLE Miter lock Handle BEVEL SCALE Fig. 21 20 VIEW OF Blade NOT SQUARE WITH Miter Table, ADJUSTMENTS ARE REQUIRED Fig. 24