Ryobi TS1143L User Manual - Page 26
Warning, Clamping Wide Workpieces, Cutting Warped Material
View all Ryobi TS1143L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
OPERATION Bevel Angle Setting 33.9° 33.9° 33.9° 33.9° Type of Cut Left side, inside corner 1. Top edge of molding against fence 2. Miter table set right 31.6° 3. Save left end of cut Right side, inside corner 1. Bottom edge of molding against fence 2. Miter table set left 31.6° 3. Save left end of cut Left side, outside corner 1. Bottom edge of molding against fence 2. Miter table set left 31.6° 3. Save right end of cut Right side, outside corner 1. Top edge of molding against fence 2. Miter table set right 31.6° 3. Save right end of cut CUTTING WARPED MATERIAL See Figures 30 - 31. When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 30. If the warped material is positioned the wrong way as shown in figure 31, it will pinch the blade near the completion of the cut. WRONG Fig. 31 WARNING: To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence. CLAMPING WIDE WORKPIECES See Figure 32. When cutting wide workpieces, such as 2 in. x 6 in., boards should be clamped with a C-clamp as shown in figure 32. RIGHT WIDE BOARD Fig. 30 26 Fig. 32