Ryobi FVG51K Operation Manual 1 - Page 5

FEATURES PRODUCT SPECIFICATIONS Motor...4 V DC No Load Speed (revolutions per minute approx. 175/min (RPM) Low, 300/min (RPM) Max Waterproof Rating...IPX7* * IP Rating: Specifies the environmental protection the product enclosure provides. This product has an IPX7 rating meaning it can withstand immersion in water up to 1 meter for up to 30 minutes. ASSEMBLY WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Battery tools are always in operating condition. Make sure the power button is off and remove the battery pack when the product is not in use or when carrying at your side. WARNING: Always remove battery pack from the tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below: „ The power scrubber can be used to clean exterior and interior surfaces. „ This product is not for commercial use. INSTALLING/REMOVING BATTERY PACK See Figure 1, page 8. To install: „ Unscrew and remove the battery cap. „ Insert the battery pack into the product as shown. „ Place the cap over the battery pack and push down until the cap meets the threads at the end of the tool. „ Screw the cap on securely. NOTE: Do not attempt to use this product if the battery cap is not securely closed. The cap is securely closed when the alignment triangle on the tool lines up with the alignment rectangle on the cap. To remove: „ Unscrew and remove the battery cap. „ Remove the battery pack from the tool. For complete charging instructions, see the operator's manual for your battery pack. 5 - English