Reebok 8000 Es Treadmill English Manual - Page 12
Console Base. - belt
View all Reebok 8000 Es Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12. Attach the Latch Housing (71) to the Left Upright (73) with two #10 x 1" Tek Screws (76). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Latch Screws. Locate the Latch Pin Assembly (72). Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Then, insert the pin into the Latch Housing (71), and tighten the knob back onto the pin. 12 71 Knob 72 76 Large Hole 73 Spring Collar Pin 13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 23 and 24). If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated M4.2 x 16mm Screw (12) and the Access Door (97) from the Console 88 Base (88). 2. Connect the wire on the receiver to the indicated wire extending from the Console Base (88). Hold the receiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (97) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (97) with the M4.2 x 16mm Screw (12). Discard the other wires included with the receiver. Small Screws Small Cylinder Wire Receiver 97 12 12