Rane HAL System Design Guide - Page 43
Connection Diagram, Con for: Dynamic Mic, Condenser Mic with 24 V phantom power, Unbalanced L+R
View all Rane HAL System manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
CHAPTER 2: Introduction to the HAL System l Flexible Inputs o Two universal Mic/Line/Line-Plus Inputs n Rear panel Euro connectors n Configure for: Dynamic Mic, Condenser Mic with 24 V phantom power, Unbalanced L+R Mono or Balanced Line o Aux Input via mini TRS jack n End user accessible input n Configure for Mono or Stereo Input n Read-only Logic indicates insertion of mini TRS l Flexible Outputs o Two balanced line-level outputs n Rear panel Euro connectors n Line Mute control o Headphone output via mini TRS jack n End user accessible n Read-only Logic indicates insertion of mini TRS n Headphone Mute control o Dual Class-D amplifier n 1X8 watts into 8 ohms in Single channel mode n 2X4 watts into 8 ohms in Dual channel mode n Integrated power limiter n Amp Mute control l Logic I/O o Rear panel Euro connectors n Three Logic inputs o Three Logic outputs n Directly drive LEDs with up to 5 mA n Open collector output accommodates +24 volts at 0.5 A l DR3-style remote control capable of simultaneously supporting a mix of Level, Selector, Toggle and Command controls on a higher resolution color display. l Signal/Overload & infrastructure Diagnostic Indicators on Top as show in Figure-2 below Connection Diagram The RAD26 is connected to a HAL in a similar way to how the DR6 is connected. It requires the included Remote 37