Pyle SLHP34L Instruction Manual - Page 5

Press the ON/OFF Button on the Control. The display will illuminate, the all icon will displayed for 1.5 seconds. 4. "105°F" will display, indicating the Control Fig.3 is set at the lowest heat setting, "60m" will display, indicating the Control is set at the 60 min auto o (see Fig. 3). WARNING: Burns can occur regardless of the control setting. Check skin under Pad frequently. 5. To change the heat setting, press the "+" Button for a Fig.4 higher heat level or the "-" Button for a lower heat level. The desired heat level and the heat mode icon will appear for about 3 seconds, and then display the real- time temperature of the pad. (see Fig. 4). 6. Display of Settings, display as 6 setting, display as 3 setting. NOTE: If the Control shuts o , make sure the Pad and Control connectors are securely connected and re-start the product by pressing " ". 7. Place the Pad on top of the body. If the Pad does not evenly heat, make sure there are no folds or bunched up areas. 8. Turn the product o by pressing the Button and unplug it when it is not in use. AUTO OFF FUNCTION This product willturn o after a set duration of time. Settings are 0.5 hour (30 minutes), 1.0 hour and 1.5 hours (90 minutes). WARNING: Burns can occur regardless of the control setting; check skin under Pad frequently. Unplug the product when it is not in use. 1. After turning the Pad on and selecting the desired heat setting (steps 4 and 5 above), press the " " Button or the " " Button until the desired amount of time is displayed. The display will illuminate the desired amount of time (for example "60m"), Time numerical display ickers for 3 seconds, and then the desired time setting will display steadily (see Fig. 5). Fig.5 5 www.SereneLifeHome.com