Pyle PLVSWI15 Instruction Manual - Page 2

Please read instructions carefully before installation and use. General Introduction This unit allows multiple cameras to be connected and displayed onto a single channel monitor. Each camera can be displayed individually onto the monitor when the corresponding trigger wire is activated. Example, left side mount camera is displayed when left turn signal is activated, right side mount camera displayed when the right turn signal is activated. Rear camera is displayed when in reverse gear. Front camera is displayed default on or can be manually triggered with an optional ON/OFF switch. CONNECTIONS: 1. Connect the RED wire to accessory wire +12 volts DC. 2. Connect the BLACK wire to chassis ground. 3. Channel 1 Trigger wire, FRONT camera trigger is Default ON. NOTE: An optional trigger switch can be installed to control when the front camera is displayed. Separate the two connected white wires and install an ON/OFF switch. 4. Channel 2 Trigger wire, LEFT camera trigger. Connect this wire to the +12 volt left turn signal wire. 5. Channel 3 Trigger wire, RIGHT camera trigger. Connect this wire to the +12 volt right turn signal wire. 6. Channel 4 Trigger wire, REAR camera trigger. Connect this wire to the +12 volt reverse light signal wire. 7. Connect the RCA cable from each camera to the corresponding 1-4 video inputs. CHANNEL 1 = FRONT CAMERA CHANNEL 2 = LEFT CAMERA CHANNEL 3 = RIGHT CAMERA CHANNEL 4 = REAR CAMERA 2 www.PyleUSA.com