Pyle PLAM2001D PLAM2001D Manual 1 - Page 2
Installation
View all Pyle PLAM2001D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Congratulations on purchasing the High Speed Power Amplifier. The amplifier has been designed using the latest electronic technology available, allowing you to produce high quality stereo reproduction in mobile applications. This system provides you with low harmonic distortion, a huge considerable amount of reserve voltage and high temperature stability. Just enjoy the perfect sound this amplifier takes to you! INSTALLATION * Since the amplifier is sensitive to electrical and motor noise and interference from the amplifier may affect your radio reception, try to mount it at least 3 feet away from the receiver. Good locations include under a seat, in the trunk or hatch area. * Please remember this is a high power unit which generates high electrical energy and heat. Therefore be sure to install the unit in a place with sufficient airflow, a minimum of dust and no moisture. Allow enough space around the cooling fins to permit reasonable airflow and cooling. It is important to ensure that the cooling fins of the heat sink are not against a panel or a surface preventing air circulation. * Never mount the amplifier in a location that is subject to direct sunlight or exposed to moisture. Be sure to mount the amplifier to a strong, solid surface which will not give way under the stress of a sudden stop or accident. * When mounting the amplifier on a side wall, try to position it so that the slots in the cooling fins are vertical. Amplifier should not be mounted on the bottom of a rear deck with the fins facing down because the heat will radiate back up into the amplifier. Leave yourself enough room on either side of the amplifier to make all the wire connections and adjust the controls. If you have a subwoofer box in your vehicle, you can mount the amplifier on the outside of the box. Caution: If you are mounting the amplifier to the vehicle's floor, check beneath the car to be sure your screws won't puncture a brake or gas line. WARNING! Continuous exposure to sound pressure levels over lOOdB may cause permanent hearing loss. High power autosound system may produce sound pressure levels well over 130dB, use common sense and practice safe sound please! Specifications Output Power Rating • 4 Ohms • 2 Ohms • 1.3 Ohms Maximum Power Output Frequency Response PLAM20D1D 1x500W 1x800W 1x1200W ,ooow 10Hz-150Hz Input Sensitivity Signal To Noise Ratio 0.2-6. QV >95dB THDlNoise High Pass Cross Frequency Low Pass Cross Frequency 95dB