Pyle PDWM8350 Instruction Manual - Page 7

TROUBLESHOOTING Some common problems and their solutions are printed below. PROBLEM SOLUTION No sound; RF light(s) not glowing • Make sure the transmitter • POWER switch is ON and the receiver is plugged into a power source • Check battery. • Check receiver squelch setting. • Check receiver antenna connection(s). • Make sure antennas are in line of sight of transmitter. No sound; RF light(s) not glowing • Turn up receiver audio VOLUME control • Check for proper connection between receiver and karaoke unit Received signal is noisy; contains extraneous sounds with transmitter on. • Check battery • Remove local.Sources of RF interference. • If using a guitar or other instrument, check connections. • Two transmitters may be operating on the same frequency. Locate and turn one o . • Signal may be too weak, reposition antennas. If possible, move them closer to transmitter. Noise from receiver with transmitter o . • Adjust receiver squelch control. • Remove local sources of RF interference. • Reposition receiver or antennas. Momentary loss of sound as transmitter is moved around performing area. • Reposition receiver and perform another walkthrough test and observe the RF indicators. If audio drop outs persist, mark these dead spots in performing area and avoid them during performance 7 www.PyleUSA.com