Panasonic WVSP306 WVSP302 User Guide - Page 63

Configure the settings relating to the alarm output terminal [Alarm] Click the [Alarm] tab on the "Alarm" page. (☞ Pages 22 and 23: How to display/operate the setup menu) The settings relating to the alarm output terminal can be configured in this section. [Pulse width] When "Pulse" is selected for "Alarm output type", select an alarm output terminal duration from the following. Available range: 1 - 120sec Default: 1sec ■ Alarm output terminal setup [Alarm output trigger] Select "On" or "Off" to determine whether or not to output the alarm signals to the alarm output terminal when an alarm is detected. Default: Off [Alarm output type] Select "Latch" or "Pulse" for the alarm output terminal at an alarm occurrence. Latch: When an alarm is detected, the alarm output terminal will be in the state selected for "Trigger output" until the alarm occurrence indication button is clicked. Pulse: When an alarm is detected, the alarm output terminal will be in the state to the "Trigger output" setting for the period set for "Pulse width". Default: Latch [Trigger output] Select "Open" or "Close" to determine whether to open or close the alarm output terminal when outputting the alarm signals. Open: The alarm output terminal will open when out- putting the alarm signals. (Normally close) Close: The alarm output terminal will close when out- putting the alarm signals. (Normally open) Default: Close Note: • When "Open" is selected, the alarm signal will be output for around 20 seconds when the power of the camera is turned on. 63