Panasonic PT-EW730ZU Spec Sheet - Page 14
Control commands, Cable specifications
![]() |
View all Panasonic PT-EW730ZU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
LCD Projectors Cable specifications PT-EW730Z/EW730ZL Control commands Command : Parameter PON POF OSH:0 OSH:1 IIS:DL1 IIS:DP1 IIS:HD1 IIS:DVI IIS:RG1 IIS:RG2 IIS:VID VXX:RYC2=+00000 VXX:RYC2=+00001 VXX:LPWI1=+00030 VXX:LPWI1=+00001 VXX:LPWI1=+00020 VXX:LPWI1=+00021 OAS VSE:0 VSE:1 VSE:2 VSE:5 VSE:6 VSE:9 VSE:10 VPM:NAT VPM:STD VPM:DYN VPM:CIN VPM:DIC Function Standby power Shutter Input selection RGB2 INPUT SETTING Lamp power Auto setup Aspect Picture On Off Off On DigitalLink DisplayPort HDMI DVI-D RGB1 RGB Video RGB/YPBPR S-Video Auto Normal Eco 1 Eco 2 Normal/Auto/VID Auto 4:3 Wide Real Full H-fits V-fits Natural Standard Dynamic Cinema DICOM Simulation Callback PON POF OSH:0 OSH:1 IIS:DL1 IIS:DP1 IIS:HD1 IIS:DVI IIS:RG1 IIS:RG2 IIS:VID VXX:RYC2=+00000 VXX:RYC2=+00001 VXX:LPWI1=+00030 VXX:LPWI1=+00001 VXX:LPWI1=+00020 VXX:LPWI1=+00021 OAS VSE:0 VSE:1 VSE:2 VSE:5 VSE:6 VSE:9 VSE:10 VPM:NAT VPM:STD VPM:DYN VPM:CIN VPM:DIC * Do not send PON, POF or OSH commands continuously in a short period of time. Doing so may burst the lamp or shorten the lamp replacement cycle. * When a command that cannot be executed during standby mode is sent, the projector will send an ER401 command in reply. As of October 2013 SFL13M004 14/17
![](/manual_guide/products/panasonic-ptew730zu-spec-sheet-3ee602e/14.png)