Panasonic PT-DZ870 ET-PKD130B Installation Instructions - Page 16

Using an existing bracket (continued) Mounting the projector on an existing bracket To combine this product with an existing ET-PKD120H, ET-PKD120S, ET-PKD310H, ET-PKD310S, ET-PKD56H, ET-PKD55S, ET-PKD100H, ET-PKD100S, ET-PKD77H and ET-PKD75S, use the steps on pages 12 to 14 to install this product and the drop prevention kit supplied with the product on the projector. Then install the projector on the existing ceiling mount bracket according to the following instructions. Note zzThe illustration shows an installation using the ET-PKD56H ceiling bracket for high ceilings. Other ceiling mount brackets for low or high ceilings can be installed according to the same procedure. zzThe illustrations of projectors are for informational purposes only and do not represent a specific model. Configurations may vary with the model. Projector mount bracket Angle adjusting bracket 1) Align the screw holes on the angle adjusting bracket with the holes on the projector mount bracket and secure the bracket with the six captive washer hex head bolts removed in the section "Removing the projector from the existing bracket", as shown in the figure on the left. Attention zzAfter adjusting the installation angle, tighten the six captive washer hex head bolts firmly. For information on how to adjust the installation angle, refer to the installation instructions or other instructions supplied with the ceiling mount bracket (for low or high ceilings). Hex head bolt, captive washer Note zzThe illustration of the angle adjusting bracket is for informational purpose only and does not represent a specific product. Tightening positions of the captive washer hex head bolts may vary depending on the shape of the angle adjusting bracket. Angle adjusting bracket Hex head bolt, captive washer 16 - ENGLISH