Panasonic EW-1213 Operating Instructions - Page 9

English Parts identification  Front  Back                     A Main unit > Nozzle stands 1 Nozzle release button ? Screw holes for wall 2 Power switch [0/1] mounting 3 Mode switch The charger can be 4 Mode indicator mounted on a wall 5 Charging indicator using two wood screws. 6 Ventilation hole C Nozzle (for general use) 7 Suction hose @ Nozzle 8 Filter A Nozzle handle 9 Water tank B Identification ring  Water tank cap D Orthodontic nozzle B Charger (RE8-53) Accessories  Charging section E 2 screws  Cord  Power plug Note There may be moisture inside the main unit (water tank and suction hose) left from the distilled water used for product testing. Charging ►►On the bathroom countertop or a shelf 1. Place the cord in the right, left or center cord guide, depending on where the charger will be placed. 2. Place the charger on a secure, level surface. 3. Plug in the power plug. 1 Insert main unit so it stands upright in the charging section. The charging indicator will light up. • Be sure to place the main unit upright. If the main unit is tilted or not in direct contact with the charger, the main unit may not charge properly. • Charging is completed in about 15 hours. • The lamp does not go off even when charging ends. • The main unit will provide an operation time of approximately 15 minutes of use when the battery is fully charged. (The operating duration will become shorter as the batteries get older.) 9 EW1213_US.indb 9 2020/06/22 16:53:07