Panasonic DMREZ17K Dvd Recorder - Page 57

General Issues Operation Page Cannot operate the TV or Set • Change the manufacturer code on the remote control. 48 Top Box with the unit's remote • Select TV or Set Top Box mode on the remote control. 48 control. The remote control doesn't • The remote control code is wrong. Change to the correct code. 55 work. • The batteries are depleted. Replace them with new ones. 5 • Point the remote control at the remote control sensor on the main unit. 5 • Remove obstacles between the remote control and main unit. − • Remove dust from the transmission window and the unit's sensor. − • Colored glass may obstruct the signal reception/transmission. − • Don't place the signal sensor in direct sunlight or in areas that may be − subject to sun exposure. • It may be necessary to set the code on the remote control again after 55 changing the batteries. • It may be necessary to set the manufacturer code again after 48 changing the batteries. The unit is on but cannot be operated. • Some operations are prohibited by the disc. − • The unit is warm ("U59" appears on the unit's display). Wait until "U59" − disappears. • One of the unit's safety devices may have been activated. − Reset the unit as follows: Press [POWER 8] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (➔ 55, "To restore the unit if it freezes"). "U88" is displayed and the disc • The unit is carrying out the recovery process. Do the following to eject − cannot be ejected. the disc: (1) Press [POWER 8] on the main unit to switch to off. If the unit doesn't switch to off, reset the unit (➔ 55, "To restore the unit if it freezes"). (2) While the unit is off, press and hold [g] and [CH 1] on the main unit at the same time for about 5 seconds. (Ejection may take extra time depending on discs.) The disc may be defective. Try another disc. Cannot eject a disc. • The unit is recording. − • The unit may have a problem. Eject the disc as in (2) above. − Startup is slow. • Startup takes time in the following situations: − - A disc other than a DVD-RAM is inserted. - The clock is not set. - Immediately after a power failure or the AC power supply cord is connected. A password screen appears • If the television starts receiving a broadcast with the set rating 36 and you are unable to view or information, a password screen appears and you will be unable to record.
view or record. Enter your password to continue. Time is incorrect after using • Try again. If the time is still incorrect, set the clock manually (➔ 32). 47 Auto Clock Setting. Reference 57 RQT8850