Panasonic AK-HRP200G System Camera and Switcher Product Lineup Catalog - Page 51
RS-422 Connector <RS-422>, V IN Connector, EXT Connector [EXIT], AUDIO IN Connector [AUDIO IN]
View all Panasonic AK-HRP200G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Studio Camera System Dimensions (Front) (Side) Unit: mm(inches) Rear View As of April, 2017 275.6 (10-27/32) 357.1 (14-1/16) 102 (4-1/32) 285.6 (11-1/14) Remote Camera System (Bottom) 356.6 (14-1/32) 396.9 (15-19/32) ø 51 (ø 2) Mounting the camera to the installation surface When fixing directly to the installation surface Pass the cables through the bottom wiring hole or side wiring hole before putting the camera down on the installation surface. Spring washer and flat washer, x4 of each (supplied accessory) Unit mounting bolt x4 (supplied accessory) 230 (9-1/16) 179.7 (7-1/16) 4-ø 8.5 (ø 11/32) 176 (6-15/16) Pin Configuration RS-422 Connector 12 V IN Connector This RS-422 connector (RJ45) is connected when exercising serial control over the unit from an external device. Use a cable with the following specifications for the connection to this connector. The tally lamp can be lit by shorting the TALLY signal (pin 2) with GND (pin 1). • Do not apply a voltage to the TALLY signal pin. 32 1 4 Pin NO. 1 2 3 Signal GND - - LAN cable*1(category 5 or above, straight cable), max. 1000 m (3280 ft) * Use of an STP (shielded twisted pair) cable is recommended. Pin NO. Signal Pin NO. Signal 1 GND 5 TXD+ 4 HA16RA-4P (77) (Hirose Electric Co.) +12V EXT Connector [EXIT] 2 TALLY 6 RXD+ 3 RXD- 7 - 4 TXD- 8 - AUDIO IN Connector [AUDIO IN] Output connector for washer control and DC 12 V 41 32 Pin NO. 1 2 3 4 Signal GND Hot Cold DC 12V OUT External audio (LINE) input connector Pin NO. Signal HR10A-7R-4SC (73) (Hirose Electric Co.) 3 2 4 6 15 1 INPUT1 Common 2 INPUT1 Hot 3 INPUT1 Cold 164) 4 INPUT2 Common Amphenol LTW 5 INPUT2 Hot TECHNOLOGY CO., LTD. 6 INPUT2 Cold 51 Live Switcher