Panasonic AJSD955A AJSD930 User Guide - Page 62
Rack Mounting
View all Panasonic AJSD955A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Rack mounting The unit can be mounted into a 19-inch standard rack using the optional rack-mounting adaptors (AJMA75P). For the installation rails, it is recommended that the 18-inch rail and bracket (model number CC3061-99-0400) by Chassis Trak be used. (The complete slide rail and bracket unit is not available from Panasonic.) For further details, consult your dealer. 4 Attach the AJ-MA75P rack mount adapter using the same 4 screws. 1 Attach the inner members of the slide rails. Refer to the figure below for the locations where the screws are to be attached. Locations where the screws are secured on the right (R) side of the inner members of the slide rails A BC DE F GH Rack-mounting adaptors 5 Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack. After the unit has been installed, check that it moves smoothly along the rails. Standard rack Inner member OThe length of the screws used is subject to restriction. Use screws which are less than 10 mm long in their place. OAttach the inner members at the same symmetrical positions on the left (L) side. OFix the members in place using 3 screws on each side (total: 6 screws). O The letters "A" to "H" are not actually marked on the side panels. 2 Attach the outer member brackets to the rack. Check that the height is the same for the left and right brackets. 3 Remove the four screws at the front for attaching the left and right side panels. Fasten it to the rack with set screws. OKeep the temperature inside the rack to between 5°C and 40°C. O Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out. 62