Panamax M4300-EX Manual - Page 3
M4300 -EX Back Panel Connection Features, M4300 -EX Front Panel Features - power conditioner
UPC - 050616007849
View all Panamax M4300-EX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
M4300 -EX Front Panel Features Power Button Press and hold for 2 seconds to turn Bank 2 outlets ON or OFF. Power LEDs Indicates the status of the rear panel outlets. LEDs for each outlet bank will be lit when the outlets are turned ON. They will flash during the startup and shutdown process. Unsafe Voltage Indicator Normally Off. Flashes to indicate that the incoming line voltage is unsafe and the unit has disconnected the power to protect your equipment. M4300-EX BANK 1 ALWAYS ON BANK 2 ON POWER AND FILTRATION WIRING OK UNSAFE VOLTAGE Wiring OK LED Normally On. Indicates that the wall outlet is properly grounded and Line/Neutral polarity is correct. Home Theater Power Conditioner M4300 -EX Back Panel Connection Features Circuit Breaker Automatically opens when the current load is greater than 15 Amps. Push to reset. Outlet Bank 1 Four always on outlets. Power will only be turned off under a fault condition. (See specifications for over-voltage and under-voltage thresholds) The High Current outlet provides power from a non-inductive noise filtration circuit that does not limit the current to your equipment. Its output is noise isolated from all of the other outlets. Power from the other three always on outlets is cleaned by a twostage tapped Pi filter circuit which provides noise isolation from both the High Current outlet and Outlet Bank 2. Outlet Bank 2 Four switched outlets controlled by the front panel Power Button. EMI/RFI noise filtration is provided by a two stage tapped Pi filter circuit which also provides noise isolation from all four outlets in Bank 1. Satellite TV Coax Jacks Bidirectional protection circuit optimized for satellite TV signal lines. Do not use for cable TV off-air antennas and cable modems. Cable TV Coax Jacks Bidirectional protection circuit optimized for cable TV, off-air antennas and cable modem signal lines. Do not use for Satellite TV. MAIN POWER 120 VAC/15A 15 AMP CIRCUIT BREAKER GROUND LUG HIGH CURRENT BANK 1 ALWAYS ON BANK 2 SWITCHED SUB / RECEIVER DVR HDTV / MONITOR HD CABLE / SAT DVD DIGITAL RADIO CD AUX / VCR 10/100bT LAN AND PHONE LINE IN EQUIP. 1 EQUIP. 2 LAN TEL SATELLITE CATV / ANT Main Power Must be plugged into a properly wired & grounded 3-wire outlet Ground Lug Provides a common grounding point for equipment with separate ground leads. LAN / Phone Jacks Protection circuits for 10/100 baseT Ethernet and standard telephone or pay-per-view lines. Phone circuit is auto-resetting. Incoming LAN or phone cords MUST be plugged into the LINE jack. Patch cords to the equipment (satellite receiver, digital video recorder, telephone, etc.) MUST be plugged into the EQUIP jacks.. Note to CATV Installers: This reminder is provided to call attention to Article 820-40 of the NEC. That article provides specific guidelines for proper grounding.It specifies that the cable ground shall be connected to the grounding system of the building and as close to the point of entry as practical.