NordicTrack C2000 Instruction Manual - Page 9

7. Set the console assembly face down on a soft surface to avoid scratching the console assembly. Hold the Right Handrail (95) near the console assembly. Next, insert the console wire into the large hole in the Right Handrail and out of the top as shown. If necessary, use needlenose pliers to help pull the console wire out. Attach the Right Handrail (95) and the Left Handrail (not shown) with four #8 x 3/4" Screws (1) (two are shown). Make sure that no wires are pinched. Start all four Screws before tightening any of them; do not overtighten the Screws. 7 95 8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star 8 Washer (33) into the bracket and the Handrail Crossbar (94) on each side of the console as- sembly (only one side is shown). Remove the wire tie from the console wire. Console Wire 1 Hole 1 Console Assembly 5 Wire 33 Tie Console Assembly 94 9. Remove the long tie from the Upright Wire (38). 9 Have a second person hold the console assembly near the Right Upright (78) and the Left Upright (not shown). Connect the Upright Wire (38) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Attach the console assembly to the Right Upright (78) and the Left Upright (not shown) with four 5/16" x 3 1/4" Bolts (7) and four 5/16" Star Washers (10) (only two are shown). Be careful not to pinch the wires. See steps 4 and 6. Tighten the four 3/8" x 5" Bolts (6). 9 Console Assembly Console Wire 78 7 Console 38 Long Wire Tie 10 38