Metabo SSD 18 LTX 200 Operating Instructions 3 - Page 10
English
View all Metabo SSD 18 LTX 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
en ENGLISH 6.1 Battery pack Charge the battery pack before use (8). If performance diminishes, recharge the battery pack. The ideal storage temperature is between 10°C and 30°C. "Li-Power" li-ion battery packs have a capacity and signal indicator: (11) - Press the button (10), the LEDs indicate the charge level. - If one LED is flashing, the battery pack is almost flat and must be recharged. Removal: Press the battery pack release (9) button and pull the battery pack (8) forwards. Inserting: Slide in the battery pack (8) until it engages. 6.2 Setting the direction of rotation, engaging the transporting safety device (switch-on lock) Do not actuate the rotation selector switch or engage the transportation lock (4) unless the motor has stopped completely! Actuate the rotation selector switch / Engage the transportation lock (4) R = Right rotation set (insert screws) L = Left rotation set (remove screws) 0 = Central position: transportation lock setting (switch-on lock) 6.3 Switching on and off Switching on: press the trigger switch (5). Switching off: release the trigger switch (5). 6.4 Speed / Tightening torque The speed and tightening torque are connected directly. The lower the speed, the lower the tightening torque. The tightening torque is influenced in two ways: 1) Preselect maximum tightening torque. You can select one of three tightening torque settings by pressing the button (7). The maximum tightening torques are provided in the table on page 3 (MMAX, MMED, MMIN). Button (7) lights up to indicate which setting is selected. MAX = Does not light up = max. torque MED = Flashing = medium torque MIN = Continuously lit = min. torque 2) Stepless adjustment of the tightening torque: The speed and tightening torque can be adjusted steplessly by pressing the trigger (5) firmly or lightly, thus adapting to working conditions. Recommendation: determine the correct setting by carrying out trial screwdriving. 10 6.5 Changing screwdriving bit for SSD... Inserting screwdriving bit: Slide locking sleeve (3) forward and insert screwdriving bit as far as the stop. Release locking sleeve (3). Pull on the screwdriver bit to check that it is correctly seated. Removing screwdriving bit: Slide locking sleeve (3) forward and remove screwdriving bit. Only use screwdriving bits with such plug-in ends: 9,5 mm (3/8") The screwdriving bit used must match the screw. Damaged screwdriving bits must not be used. 6.6 Changing SSW... screwdriving bits Inserting screwdriving bit: Fit the tool on the square attachment (1) until the limit stop. Removing screwdriving bit: Pull the tool from the square attachment (1). The screwdriving bit used must match the screw. Damaged screwdriving bits must not be used. 7. Use Mount the machine on the screw, ensuring it is aligned straight. The screwdriving process has two elements: inserting the screw and tightening the screw with the percussion mechanism. The tightening torque depends on the impact duration. With an impact duration of approx. 5 seconds, the maximum tightening torque has been reached. The torque curve depends on the type of application: With a hard screwdriving application (screwcouplings in hard material such as metal), maximum tightening torque is already reached after a short impact duration (a).