Metabo MHEV 5 BL Operating Instructions - Page 11
Cleaning, Maintenance, Troubleshooting, Accessories, Repairs, Environmental Protection, Technical
![]() |
View all Metabo MHEV 5 BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
The correct setting is found by trial and error. Example: if work is being completed on soft, brittle material or if you want to keep breakage to a low level, work at "reduced impact force". Use the "maximum impact force" setting for working with harder materials. 7.5 Switching on and off Torque setting: Press the trigger switch (9) to switch on the machine. To switch off release the trigger switch (9). Continuous operation (only in chiselling mode ): The machine can be switched to continuous operation (only in chiselling mode ) by pressing the (10) button. ( (10) button illuminated.) To switch off, press the (10) button once again. ( (10) button not illuminated.) In continuous operation, the machine continues running if it is forced out of your hands. Therefore, always hold the machine with both hands using the handles provided, stand securely and concentrate. 7.6 Metabo VibraTech (MVT) For reduced vibrations and less stress on the hands. Always apply a moderate amount of pressure to the handle when pushing down the machine and do not force. Vibrations are reduced most effectively at the central position (8). 8. Cleaning, Maintenance The power tool should be cleaned regularly, often and thoroughly through all air vents using a vacuum cleaner or by blowing in dry air. Prior to this operation, separate the power tool from the power source and wear protective glasses and dust mask. 9. Troubleshooting ENGLISH en Use only accessories that fulfil the requirements and specifications listed in these operating instructions. See page 4. A Extensive drill bit and chisel assortment for a wide range of applications. B Special grease (for lubricating the tool shanks) C Dust extraction system For a complete range of accessories, see www.metabo.com or the catalogue. 11. Repairs Repairs to electrical tools must ONLY be carried out by qualified electricians! The connection cable must only be replaced by Metabo or an authorised customer service workshop. Contact your local Metabo representative if you have Metabo power tools requiring repairs. See www.metabo.com for addresses. You can download a list of spare parts from www.metabo.com. 12. Environmental Protection Observe national regulations on environmentally compatible disposal and on the recycling of disused machines, packaging and accessories. Only for EU countries: never dispose of power tools in your household waste! Used power tools must be collected separately and handed in for environmentally compatible recycling in accordance with European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in national legal systems. 13. Technical Specifications Explanatory notes on the specifications on page 3. Changes due to technological progress reserved. Elektronic signal indicator (12) Flashing - restart protection When power is restored after a power failure, the machine - which is still switched on - will not start for safety reasons. Switch machine on and off again. Continuously illuminated - overload If the machine is overloaded for a long period of time, the power intake is limited to avoid further excessive heating of the motor. Allow the machine to run at idle speed until it has cooled off and the electronic signal indicator goes out. 10. Accessories Use only genuine Metabo accessories. PnDP0121 = Rated input power = Power output = No-load speed = Max. drilling diameter in concrete with impact masonry bits D2 = Max. drilling diameter in concrete with impact core cutters sWmax = Maximum impact rate = Single impact force C = Number of chisel positions m = Weight without mains cable Measured values determined in conformity with EN 60745. Machine in protection class II ~ AC power The technical specifications quoted are subject to tolerances (in compliance with relevant valid standards). Emission values 11
![](/manual_guide/products/metabo-khev-540-bl-operating-instructions-b6f538d/11.png)