Maytag MDPS6124R Owners Manual - Page 7
Error Codes
View all Maytag MDPS6124R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ERROR CODES ERROR CODES / BLINKING LIGHTS Issue Code Shown (7 Seg Display) (if present) Dishwasher fails to operate fill valve correctly Motor controller failure No water present at dishwasher F1E1 F1E2 H2O Wash motor failure F7E1/F7E2 Dishwasher overfills F8E4 Fill valve stuck on F8E5 Dishwasher will not drain Water present under dishwasher User interface service communication fault F9E1 FAE5 F6E1 Code Shown on Front Panel LED * (# blinks, Pause, # blinks) 1 Pause 1 Pause - pause, repeat 1 Pause 2 Pause, repeat 8 Pause 1 Pause - pause, repeat 7 Pause 1 Pause, repeat/7 Pause 2 Pause, repeat 8 Pause 4 Pause pause, repeat 8 Pause 5 Pause pause, repeat 9 Pause 1 Pause pause, repeat 10 Pause 5 Pause pause, repeat What will happen? Drain sequence will begin, machine operation will be prevented Cycle ends Cycle is paused Cycle ends Drain sequence will begin, machine operation will be prevented Drain sequence will begin, machine operation will be prevented Cycle ends Cycle ends What to do? Turn off water to unit (if possible).Turn off power to unit. If the water cannot be turned off, DO NOT turn off power and keep door closed. Press Cancel key one time to silence alarm tone. Call service. Call service Ensure fill hose is connected to product. Ensure water supply is turned ON. Press Start to resume cycle. If alarm still present, call service. Call service For Professional Installers Turn off water to unit (if possible). Turn off power to unit. If the water cannot be turned off, DO NOT turn off power and keep door closed. Press Cancel key one time to silence alarm tone. Call service. For Self Installers ■ Press CANCEL button twice or cycle power. This may clear the issue. ■ Check to see if the wire connector is connected to the float switch on the drip tray. See step 46. If the wire is off, reconnect and then hit the cancel button twice. ■ Check to see if there is any water in the drip tray. If water is in the drip tray, remove the water and reinstall the drip tray. Make sure to connect the wiring to the float. Step 46. Check to see where water may have leaked into the drip tray. (Check the water inlet fittings in steps 15 and 16 to see if they are leaking) ■ If water was in the tray and no leaks were found, run the product on the shortest installation cycle while checking for leaks. The access panel should be off to observe any leaks. ■ If problem still exists, call for service. Turn off water to unit (if possible).Turn off power to unit. If the water cannot be turned off, DO NOT turn off power and keep door closed. Press Cancel key one time to silence alarm tone. Call service. If drain hose is connected to a garbage disposal, confirm that drain hose is not clogged and disposal plug has been knocked out. If unit still will not drain, call service. Call service. 6 Pause 1 Pause pause, repeat Product will not able to start or resume cycles Call service. 7