Marantz VP-10S1 VP10S1 User Manual - Page 41
English
![]() |
View all Marantz VP-10S1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
ENGLISH 5. Loosen the 2 screws that lock down the lamp cover. (Slotted head screwdriver required.) 6. Detach the lamp cover in the direction of the arrow. Lamp cover 10. Fit the top end of the lamp shield back into place as shown below, followed by the bottom end. Lock the lamp shield in place with the 2 screws removed in step 7. (Phillips screwdriver required.) 2 21 2 2 Lamp shield 11. Fit the bottom end of the lamp cover back into place as shown below, followed by the top end. 2 7. Remove the 2 screws that lock down the lamp shield. (Phillips screwdriver required.) Pull the lamp shield downward as indicated in the below figure and detach. 1 1 1 2 1 Lamp shield 8. Loosen the 2 screws that lock down the lamp unit. (Slotted head screwdriver required.) Grab the lamp unit by the handle and pull the unit out toward you. 1 1 12. Lock the lamp cover in place with the 2 screws loosed in step 5. (Slotted head screwdriver required.) 13. Plug in the AC power cable, turn on the projector and project an image. • If you replaced the lamp before 1,500 hours of service, see "Reset Lamp Life" ( pg. 32). • If you replaced the lamp after 1,500 hours of service, see "Resetting the Lamp Life Counter" ( pg. 36). 2 1 Lamp unit 9. Install a new lamp unit securely in the correct orientation. Lock the lamp unit in place with the 2 screws. (Slotted head screwdriver required.) Fold the handle over as it was before. 2 2 1 New lamp unit 37
![](/manual_guide/products/marantz-vp10s1-vp10s1-user-manual-1e0cf1d/41.png)